Hey so I got the ac to work turns out it's cuz it wasn't calibrated. But, I can't control the fan speed it's only on high. Is yours the same way if not how'd youget that to work?
@xanu8isx Did you install the Blower resistor that screws in with 2 screws into the air box under the dash? If that piece is from non digital it could make it only blow full speed, or if the one you have is bad it can also do the same thing.
@xanu8isx As long as you wired everything up per the instructions everything should be fine! Did you do an engine swap? If you did, make sure the (I think) green wire under the dash is hooked into the new wiring harness!
@xanu8isx Sorry for the late reply, but you hold the off or auto button for at least 5 seconds, within the first few seconds that you turn your key to the on position.
Nice video.knowledge! Haha. Thanks
CRITIKCK 5 months ago
Hey so I got the ac to work turns out it's cuz it wasn't calibrated. But, I can't control the fan speed it's only on high. Is yours the same way if not how'd youget that to work?
xanu8isx 6 months ago
@xanu8isx Did you install the Blower resistor that screws in with 2 screws into the air box under the dash? If that piece is from non digital it could make it only blow full speed, or if the one you have is bad it can also do the same thing.
Acecool 6 months ago
Hey did you get your ac to work with your dcc?
xanu8isx 8 months ago
@xanu8isx As long as you wired everything up per the instructions everything should be fine! Did you do an engine swap? If you did, make sure the (I think) green wire under the dash is hooked into the new wiring harness!
Acecool 6 months ago
Quick question. Where does the aspirator hose come in to all of this? I noticed you had it in the first video, but didn't see it in the other two.
gamermatt89 10 months ago
how did u get in to the diagnostic mode on the control unit?
xanu8isx 1 year ago
@xanu8isx Sorry for the late reply, but you hold the off or auto button for at least 5 seconds, within the first few seconds that you turn your key to the on position.
Acecool 9 months ago
thnx for great writeup! But on which wire on DCC harness did u connect the ambient temp sensor?
masterzipper 1 year ago
@masterzipper Light Green/Yellow is the positive wire, Solid Light Green is the negative wire for the outside ambient temperature sensor.
In Cabin Air Temp Sensor is: Brown is positive, Light Green is negative.
Acecool 1 year ago 2
nice video but, u never showed wat to do with the outside temp sensor. do i splice it on to the US one or is there a certain way to do it?
xanu8isx 1 year ago
@xanu8isx You splice it into the JDM DCC Sub-Harness
Acecool 1 year ago
@Acecool you said splice it into the jdm sub harness but you weren't specific on which colored wires. Could you please specify? Thank you
celikaboi 5 months ago