i need help

[PowerToolFun]

what kind is it?

[davidtheatheist]

Mine did that and replacing the fuel lines fixed it.

[xXSgtPugsXx]

adjust the mother fuckin jets on the carb dip shit

[jonesbrent85]

@xXSgtPugsXx shut up jerk it was not that any way it had low spark

[Jon3800]

Ya, I had this problem plague my Shindaiwa 22F.  Extremely hard starting...would never rev all the way, bog down and quit.

Thankfully I fixed it by cleaning the small jets in the carb and removing the specs of dirt underneath the needle and seat.. Put it all together and it ran perfect.

Sucks you sold it..but next time it happens to any of your trimmers, you'll know what to do.

[jonesbrent85]

@Jon3800 i tride all that so it just needed a new carb

[mexicanchipmunk1119]

U should of filled out the warrentie stupid.When my head on the weed wacker broke they sent me a new one for free. Maybe u can fill it out and get a new on would not cost u a penny

[jonesbrent85]

@mexicanchipmunk1119 who are calling stupid it was out of warrentie

[savagenomore]

did you ever get it fixed?

[jonesbrent85]

@savagenomore no i sold it for $40

[tractor6759]

Carb rebuild

[gasman221001]

carb may be

[jonesbrent85]

@gasman221001 it needs a new one it bin rebult and cleaned so im thing it needs a new one

[exmarkmetroguy]

yup as these fellows mentioned it would probably be the carbs jets your air filter or build up in the out take exhaust place! and definitly listen to donyboy73 he is boos when it comes to engines

[froggyman222]

carborator clean the carb

[Mightylite94]

@froggyman222 SHUT UP!!! YOU KNOW JACKCRAP ABOUT WEEDEATERS, BLOWERS AND EVERY OTHER ENGINE. OK, THIS MACHINE MOST DEFINETLY NEEDS A CARB CLEAN, BUT ITS THE MUFFLER AND OUTAKE PLACES THAT NEEDS TO BE CLEANED.

[jonesbrent85]

@Mightylite94 i did all that and it still runs like junk.

[Mightylite94]

@jonesbrent85 did you check the piston, and the seating, it could also be bad filters and a plug

[Mightylite94]

@jonesbrent85 did you adjust the carb, like high and low?

[jonesbrent85]

@Mightylite94 there is now high and low screw

[Mightylite94]

@jonesbrent85 what? thats wierd.... replace the carb then cuz it might have a broken check ball, which if its broken, then its cheaper to just buy a new carb

[jonesbrent85]

What if that dose not work?

[donyboy73]

turn out the L & H screw out in 1/8" increments until it doesn't die then fine tune it later

[th19940305]

@donyboy73 most echoes dont have H and L screws on them