Thanks for reply, im fairly new to fpv and just trying to get all my facts right :) i have this diversity board now , i can get the 2 green signal rx lights flashing like yours alternate like police lights, but when i plug the 2 recievers in the lights still just flash the same, where ever i put the tx in the room the lights still flash excatky the same alternate pattern the same speed as when rx are not on. Any guidance on set up would be awesome please as im a bit stuck.
@djhoodski I don't think so, the RX in this system is not outputting any signals. Running the TX without an antenna however will burn out a module if it goes on to long. It will overheat with no where to dissipate the signal.
Sorry Guys, I didn't notice these comments. Look on RCGroups for the data sheet for these RX's there are a few different versions so verify your channel selection matches the data sheet your looking at... Also I suggest building a buffer with op amps, Mine works fine without them but other diversity switches might load the rssi voltage and actually diminish the signal and cause problems for the receivers.
Thanks for reply, im fairly new to fpv and just trying to get all my facts right :) i have this diversity board now , i can get the 2 green signal rx lights flashing like yours alternate like police lights, but when i plug the 2 recievers in the lights still just flash the same, where ever i put the tx in the room the lights still flash excatky the same alternate pattern the same speed as when rx are not on. Any guidance on set up would be awesome please as im a bit stuck.
djhoodski 5 days ago
I read that if you power up the rx without antenna it burns it out? Just wondering if thats true?
djhoodski 5 days ago
@djhoodski I don't think so, the RX in this system is not outputting any signals. Running the TX without an antenna however will burn out a module if it goes on to long. It will overheat with no where to dissipate the signal.
Charlienofun 5 days ago
Sorry Guys, I didn't notice these comments. Look on RCGroups for the data sheet for these RX's there are a few different versions so verify your channel selection matches the data sheet your looking at... Also I suggest building a buffer with op amps, Mine works fine without them but other diversity switches might load the rssi voltage and actually diminish the signal and cause problems for the receivers.
Charlienofun 1 month ago in playlist More videos from Charlienofun
Ok so how do we set it up? What parts?
TheJclone 3 months ago
Very good that it works. I want to build it too, but I dont`t know how to get the
RSSI Signal out of these reciever. Can you help me to find it out, or where to solder
the kabels to get the wright pin? Thanks a lot! Ch.
IronDog161 11 months ago
hi work well?
MassimoHely 1 year ago