How To Check a Stihl Fuel Line for Wear & Tear

[58cheatgrass]

do you have video of fuel line replacement on Stihl 064 & 066 - 088 ? most of what you show is on smaller saws, or do you get any of the bigger saws to work on? your vids are great though even if for the smaller saws!

[donyboy73]

@58cheatgrass i do work on big saws but not as many , if i get one in i'll make some vids though

[Liamautomechanic]

good tip don, would that crack make the saw hard to start,??

[donyboy73]

@Liamautomechanic it could, how's it going?

[Liamautomechanic]

@donyboy73 not so bad buddy. the internet was down there for a while, due to a faulty line, its ok now, the other thing is doing well, u were asking about. hows the weather in canada.??

[pm270100]

The best tubes  i have seen by fair good work bob from australia

[donyboy73]

@pm270100 thanks

[vtwinbriggs101]

how do u get a piston out of a ohv engine?

[vtwinbriggs101]

dony boy id like to thank u for all the knowlage u gave me

[donyboy73]

@vtwinbriggs101 no problem man

[fordf150839]

donny rock

[jonesbrent85]

Thanks for your time to make this video

[314299]

Another great tip! Thanks.

[SuperchargedMustang5]

Alright thanks man

[krismounts]

great vid again

[TrackEmDownKennels]

im so excited i got a job for small engine repair close to home

i learn alot for you donny keep up the good work!!!!

[donyboy73]

@TrackEmDownKennels good for you!

[243generallee]

i have a mac weed wacker that the gas cap leacks

[1972FordF150]

I've had this problem quite a few times with regular fuel lines. Thumbs up!

[soverato3]

hi mate! i just increased the exhaust port size of my motorized bike (for more preformance) but do i have to increase the size of the muffler hole too??

cheers mate!

[donyboy73]

@soverato3 if u want to

[647762816]

Thanks again for the helpful information.

[SuperchargedMustang5]

Would a clogged fuel line cause my chainsaw to run for a few seconds and stall

[donyboy73]

@SuperchargedMustang5 it would, but check the filter first

[plavins1]

thank you for your videos!!! when something happens to my chainsaw i know where to come for help!!! BTW you could check out my chainsaw bike,vid is on my channel.

[lawnboy1100]

Thats a great discovery.My problem is how you change the oiler on a poulan 2150.I know you have one so could you possibly do a demo?

[matthew262]

Another great video! If the saw runs with the fuel line like this it could also create a lean condition. As you know running a saw lean for any length of time can cause some serious damage to the piston and cylinder wall.