Tekin SC4X 2-pole vs. Pro4 4-pole brushless sensored motors

[9569VLAD]

текин sc4x вроде 4 полюсный???

[evgeniuscom]

@9569VLAD 2х. откуда инфа про 4?

[9569VLAD]

@evgeniuscom

по ощущениям крутится как 4-х полюсник от кастла.

[evgeniuscom]

@9569VLAD ну а чё б и нет

[9569VLAD]

@evgeniuscom

ну тогда вопросец, что лучше, мощнее, с большим моментом?

[evgeniuscom]

@9569VLAD pro4 все еще не видал припоя на контактах :(

погоды сейчас нет чтоб на улице погонять как следует.

[450hp202turbo]

Basically the Wye will spool up faster and reach its top RPM a bit faster than the Delta wound motor. The Delta wound motor also consume more amperage than the Wye motor. If you want a hi-torque motor, the Wye-wind will let you do it with few turns. If you want speed, the Delta motor will let you do it without having to use difficult, thick wire or mess with parallel strands..

[fiercebyname]

@450hp202turbo you cant buy a slash and do an upgrade or two and think you know everything. you look like a jackass. ive been doing this for 10 years. im an auto mechanic on top of that. 1. hobbywing is cheap generic equipment. good but not for racing. same for the slash, its a basher, not a racer. and with the pro4 you must run atleast an 190 amp esc and a 60 c battery.

[450hp202turbo]

@fiercebyname i have more then just a slash .you have nothing your a nobody ?

i been into rc a lot longer then ten years i am a auto mechanic as well for 30 years . and i can tell you a thing or too about brushless combos from castles to tekin to cheap hobbywin/king/ezrun what ever mate ! the only one that looks like a fool is you.

i told you i test them back to back .Castles 3800 4 pole vs the vxl with 20mm rotor has more power simple as that .

the pole count makes no difference i find.

[fiercebyname]

@450hp202turbo your a moron. pure and simple matie. jang like to run cheap shit too. he tested that motor on his gens ace battery, only a 30c rate. and a 1/10 scale esc. and he used the 4000 kv motor. that more for the indoor tracks. and i have a hard time believing anything you say. your an "internet mechanic". the plain fact is your too cheaqp to afford this stuff. and simple concepts of brushless motors confuse you so you use you internet knowledge to make opinions.

[fiercebyname]

@450hp202turbo also i ron this motor. i run the 4600 kv in my scte. most run this motor with the rx8 like i do. and actually you have to turn the power down on the esc. in most cases its too much. keep playing with your rtr's and keep off the internet if you want to maintain some pride if you have any at all

[BaldyDaniels]

So what's the video for? Not really sure why you needed to count the magnetic pull of every pole on each motor to come to the conclusion that 4 is twice as much as 2?

[evgeniuscom]

@BaldyDaniels not for ;)

it's just my first 4-pole motor.

[icyou1999]

the new sc4x is 4-pole

[evgeniuscom]

@icyou1999 where did you get that info?

[icyou1999]

@evgeniuscom team tekin in an e-mail

[Tigerbarb202]

@evgeniuscom Where can I get pinions for the pro 4? The drive shaft is thicker that any traxxas pinions can accomidate.

[evgeniuscom]

@Tigerbarb202 HotRacing makes 48pitch pinions for 5mm shafts

e-revo.net/i/IMG17419.jpg

[fiercebyname]

@icyou1999 they would not make a 4 pole 550, they are not ROAR legal. The pro 4 is a sized down version of the T8

[450hp202turbo]

i am using 4 pole castle 3800 and it just not as much grunt as vxl can. over rated

[fiercebyname]

@450hp202turbo thats because of the kv rating you are using, the delta wind in the castle, and your probably not using a high output 1/8 scale esc with a high c rated battery

[450hp202turbo]

@fiercebyname sure mate ? vxl 2 pole 3500kv shits all over a 4 pole 3800kv

65c 130c burst .same battrey same car same esc mmp tested back to back ..

why the fuck would i install a 1/8 esc in a rwd shash ? get a grip mate you obviously dont have clue on what your talking about ,,the castles motors and there esc are just crap!

hobbywing gear works better . castles is just a rip off .

[fiercebyname]

wye and delta. wye= more torque and efficient. delta has more top end, less torque. the pro4 4000kv and the 4600kv are two very different. 4000kv is 2 turn DELTA and the 4600kv is 1 turn WYE. huge difference. 2. theres a huge difference in poles. 2 pole has more top end. 4 pole has more bottom end. its like comparing a 4 banger to a v8. 3. this motor is NOT for 2wd sc. you use an 1/8 esc because this motor needs atleast 190 amp esc to run at full potential.

[450hp202turbo]

@fiercebyname because this motor needs atleast 190 amp esc to run at full potential.?

your kidding your self all the jargon in the world dose not make up for real world testing , i have a lot bigger motors then that tekin pro 4 in higher pole count 2560kv 6 pole rated at120amp max 2200watts=150amp esc to keep it safe is all thats needed

so this pro4 would need no more then 150 amp esc . its also been tested by URC back to back with other sct 4x4 motors .and it was nothing special.

[450hp202turbo]

@fiercebyname the castles 3800kv 4pole is not delta its a 1wy , the vxl is delta

get your facts right . that is what the internet is for , research learning new things

not sticking your head in the sand and saying it will only work this way my way or nothing ! the internet is little more trustworthy then some no-body on youtube with no videos to back up there big mouth .i relies a 1y motor needs more current to run at its full kv rating but come on. on 3s the 3800 draws max of 116.7amps .

[fiercebyname]

@450hp202turbo i was talking about the tekin motors. you cannot make an opion on one motor and make it the same for the rest. i purely race. for its size it puts down the power. yea if i was bashing i would run the t8 setup with a 3s that would rip the pro4 a new asshole. when it comes down to pure racing this is a fantastic motor. its power band charateristcs are nothing but amazing. dont bash something until you own it.... plain and simple

[450hp202turbo]

@fiercebyname yeah for sure i agree totally ! if i was racing thats what i would run , tekin make the good gear thats for sure. i might try a 4600 in my new exo terra buggy just so its more derivable as its 2s max,.think it will be perfect in that buggy

i still cant see it needing a 180amp but if tekin say thats what it needs then well fuck me it must be one hell of a motor. lol cheers,

[shadow122788]

What sc truck are you going to run it in

[evgeniuscom]

@shadow122788 e-revo net