shotgun fitting

[WillLeviMarshall]

Yes worked fine make sure you carefully pack out where the action goes with wood so that the metalwork fits when your done.

Oh and also it springs back a wee bit 3 or 4 mm you need to steam for at least 1 hour per inch of wood so 2-3 hours should do it

[WillLeviMarshall]

Yes worked fine make sure you carefully pack out where the receiver goes with wood so that the metalwork fits when your done.

Oh and also it springs back a wee bit 3 or 4 mm you need to steam for at least 1 hour per inch of wood so 2-3 hours should do it

[1LonePuma]

So tell us how it worked out for you, did it work?

[x0rielx]

Hi Ian the action was removed prior to steaming.

[iansummerell]

You will have to stip and clean the action after steaming a stock like this.

[WillLeviMarshall]

Oh and also it springs back a wee bit 3 or 4 mm you need to steam for at least 1 hour per inch of wood so 2-3 hours should do it

[WillLeviMarshall]

Yes worked fine make sure you carefully pack out where the receiver goes with wood so that the metalwork fits when your done.

[DekeBlue]

How well did this work? I need to increase the drop on my stock and am thinking of trying this.

[WillLeviMarshall]

Ohh it did work too I refitted the stock and never missed again... well it was an improvement at least!