Hydrogen Generator installed in 2003 Ford 150

[bigwillchill]

also how do you know that the sodium hydroxide isnt leaving resedue on your pistons or messing up your cat? im hesitant about installing mine fearing that ill mess up my cat or leave resedue on my pistons. and backfiring lol

[bigwillchill]

i ran into a little bump. i made my small cell and i was about to install it when my brother told me. if the water is leaving and the jar is closed tightly, wont it cause a vaccum? how can i let the cell breath without making it unsafe for hydrogen to leave the cell

[photoguys2003]

where can i buy the ht7? how much is it?

[danratsnapnames]

use brash mash for flash arrestor, not stainless steel.. you want the flash arrestor to remove HEAT as well as slow the burn reaction to stop it.

[tylerakawings]

gonna do that with my 1995 f150.. as soon as i get the money.. kinda hard to get the money when ur only gettin 10 mpg...

[2007tacoma]

the manual is only $67, and the parts are only 80, not hard to make it either, my brother makes the kits and sells them at his shop

[tylerakawings]

haha manuel for 67 haha overkill much.. i can build it for 50 with pwm and everything

[convert2hybrid]

How many mpg are you getting on that f150?

[drewmaster74]

Hi,

You can lose the ground wire to the battery. just Tap a metal screw by your Hydrogen generator. The case of the Truck is Metal e.g. Ground (-). Control your system by the (+)positive or (single side)pulse width of the generator. Cheaper on buying pieces extra wires that isn't necessary.

The Drewmaster :)

[xerochaos187]

good video man keep going let us know mileage

[YoTommy1]

See previous comment.... it with a balloon full of HHO before you put it on your cell. if the flame comes through then you need to up your millet. Normally 1.5" of millet on each end is enough.

[YoTommy1]

it with a balloon full of HHO before you put it on your cell. if the flame comes through then you need to up your millet. Normally 1.5" of millet on each end is enough.

[YoTommy1]

Hey man that is great. Did you know that you can built your own flash back arrestor? I did it is really easy all you need is a 4" brass nipple and 2 barbed hos fittings. A stainless steel scrubby, some stainless mesh, (like a sink strainer but very fine) and believe it or not some millet.

tightly pack the SS scrubby in to the tube then pack millet in the end then place a piece of screen on the end and screw on your barbed connection and your done test....... See next Comment

[gtp1277]

Great set up any improvement on your MPG