True Free energy devices exist,But the Establishment doesn't want ppl to know this,Get a motor that needs no gas or electric input at LT-MAGNET-MOTORdotCOM ,Be a part of the energy revolution!
I have black magnets and it doesn´t work. They have to be silver??
I have only very very small silver magnets - they are not bigger than the small end of the battery - I tried it - and suddenly my finger was on the wire and it became very hot - also the battery was very hot, but the wire didn´t spinned.
No, they don't have to be. I had to cover my magnets with aluminum foil and it worked fine but make sure it's smooth or the friction will slow it down.
Yes, If you left it going overnight the battery will eventually drain.. but it uses very little power so the battery does last longer than you would expect.
Yes in the real world we use these every day.. they are called DC motors. Take a look inside every electrical motor and you will find magnets, copper wire and to make it all run, a power source. I'm just playing around with an over simplified version here.. It's not rocket science.. lol
It's very simple guys.. watch when I stop it from spinning near the end of the video.. you can see how I bent the copper wire.. Just do it the same kind of way. The key again is to have one end contact the battery top while the other two ends contact the magnets and it will begin to spin. If yours doent spin right away check tto see it will spin freely by hand if it doesn't your wires around the magnet might be too tight... If I get time I will take a video showing the parts..
If you made a letter "M" out of the wire and just made the two ends wrap around the magnet it will pretty much work.. you will just have to fiddle with it to get it to clear the battery.
I guess it will run until the battery dies.. I do have a horizontal one that I think would run for months on one small battery. see my homopolar motor horizontal version video.. I will be uploading a few more vids of showing how I think I could get months..
all you need are two earth magnets, a AA battery and a piece of copper wire. Bend the wire so that it makes contact with the top of the battery and the other ends contact the magnets.. Where the wires wrap around the magnets it should be loose enough to spin but tight enough to make contact.. pretty simple stuff here.. stay tuned for more designs
This has been flagged as spam show
True Free energy devices exist,But the Establishment doesn't want ppl to know this,Get a motor that needs no gas or electric input at LT-MAGNET-MOTORdotCOM ,Be a part of the energy revolution!
Stgopena1212 1 year ago
I have black magnets and it doesn´t work. They have to be silver??
I have only very very small silver magnets - they are not bigger than the small end of the battery - I tried it - and suddenly my finger was on the wire and it became very hot - also the battery was very hot, but the wire didn´t spinned.
Has anybody a tip?
Thanks
anydate 3 years ago
No, they don't have to be. I had to cover my magnets with aluminum foil and it worked fine but make sure it's smooth or the friction will slow it down.
redbullfanatic 3 years ago
Homo means gay in Finland! xD
IkxGameplayer 3 years ago
@IkxGameplayer in belgium to xD
barafjic 1 year ago
what type of wire is that
stuffboutotherstuff 3 years ago
Its just non insulated copper wire
TheB3e 3 years ago
magnets
but if they are silver they are rare-earth magnets
colinalcluster 3 years ago
wow you made it go fast. this is well good
Bonethugz4lyfe 4 years ago
would the effect change if i put 5 vires instead of one long???
qwertttytydertrt 4 years ago
as long as it closes the circuit and is able to rotate, it should work.
TheB3e 4 years ago
If you were to leave the magnet on the battery overnight would it drain the battery?
I dont happen to have a magnet here so just asking. Thanks.
hwymadness850 4 years ago
Yes, If you left it going overnight the battery will eventually drain.. but it uses very little power so the battery does last longer than you would expect.
TheB3e 4 years ago
thanks.
hwymadness850 4 years ago
That is so homo :)
TeamVirility 4 years ago
Yeah.. LOL .. who names this stuff?..
TheB3e 4 years ago
nice, best one i have seen!
rasokharas 4 years ago 2
i need some of those neodymium magnets so i can do that
dragonfire55 5 years ago 2
How long will the motor go on a fully charged battery.?
10 minutes?
Hartman98372 5 years ago
Let me try it.. I will report back soon..
TheB3e 5 years ago
I konow a motor -_- ^^ my mistake
pharmratio 5 years ago
In the real wolrd is it used there? (serious ;) )
pharmratio 5 years ago
Yes in the real world we use these every day.. they are called DC motors. Take a look inside every electrical motor and you will find magnets, copper wire and to make it all run, a power source. I'm just playing around with an over simplified version here.. It's not rocket science.. lol
TheB3e 5 years ago
true, modern marvels even says magnets are used in basically everything
nintendoplayer2 5 years ago
can u post a drawn guidance with some words? ? (im german)^^ very nice!!
pharmratio 5 years ago
It's very simple guys.. watch when I stop it from spinning near the end of the video.. you can see how I bent the copper wire.. Just do it the same kind of way. The key again is to have one end contact the battery top while the other two ends contact the magnets and it will begin to spin. If yours doent spin right away check tto see it will spin freely by hand if it doesn't your wires around the magnet might be too tight... If I get time I will take a video showing the parts..
TheB3e 5 years ago
thx!, but first i must find the right magnets
pharmratio 5 years ago
is the wire without interruption ?
pharmratio 5 years ago
If you made a letter "M" out of the wire and just made the two ends wrap around the magnet it will pretty much work.. you will just have to fiddle with it to get it to clear the battery.
TheB3e 5 years ago
it works !! :D
pharmratio 5 years ago
gwoon te lauw..
TPrograms 5 years ago
how do you do this???
161803399 5 years ago
how long can it run?
nosnoma 5 years ago
I guess it will run until the battery dies.. I do have a horizontal one that I think would run for months on one small battery. see my homopolar motor horizontal version video.. I will be uploading a few more vids of showing how I think I could get months..
TheB3e 5 years ago
use an antimatter battery with that magnet and you'll produce a real diehard that will keep going...and going...and going... very nice, r2020
robion2020 5 years ago
There's something intriguing and beautiful about simplicity. Well done.
Mikerochip1 5 years ago
Thanks! I just did a few more if you check my vids..
TheB3e 5 years ago
sweet
yaHARmeMATEY 5 years ago
isnt that the same as the earths magnetic poles?
b0b0theh0b0 5 years ago
gotta get some copper wire now!
1dante2 5 years ago
that is neat, how do you make one?
Hartman98372 5 years ago
all you need are two earth magnets, a AA battery and a piece of copper wire. Bend the wire so that it makes contact with the top of the battery and the other ends contact the magnets.. Where the wires wrap around the magnets it should be loose enough to spin but tight enough to make contact.. pretty simple stuff here.. stay tuned for more designs
TheB3e 5 years ago
dat was cool
bandito2000 5 years ago