REPAIR of The Blown Snowblower Auger Gear Case Part 3 of 4

[bowers400]

if you have greas or oil in the auger gear box how often do you need to change it?

[christopherbrian1]

I have my MTD unit apart and it has a different o-ring type seal it is part # 721-0255. Have you seen this before if so what did you replace it with the part is obsolete. The two auger gear housing halves are part number 719-0292 and 719-0293.

[dowjones64]

Hi DonyBoy -- I am a women. I am an architect now and watched my father fix alot of things over time. And I must say your videos were great! Really helped me out.

Snowed in - in Boston -- Karen

[donyboy73]

@dowjones64 i asked because usually it's only men who watch my videos, lol

[dowjones64]

thank you - I will be trying to fix my sears monster now! I don't think I could have even started without this great video - thanks again!

karen

[donyboy73]

@dowjones64 r u a woman?

[Iowaracefan]

Why didn't you clean and repaint the augers and impeller while it was apart? Look better and last longer.

[donyboy73]

@Iowaracefan customer didn't want me to paint it

[Iowaracefan]

@donyboy73 They would be much happier. Oh well customer is always right, LOL.

[thenixhex311]

i did the same thing, but ordered a whole new auger shaft and gear assembly. how does the impeller shaft come out of the yellow part? i already got the two spiral pins out, but am not sure how it comes out. its an old snowblower, and i dont wanna break anything. thanks. This vide was very helpful!

[donyboy73]

@thenixhex311 it's just pressed in there, but m,ay be hard to remove due to rust

[Smallgasengine1]

what does the washers do?

[PGXI]

i like that double auger pulley system,

heavy duty....my craftsman only has one belt....nice job donyboy73