Hi, I have to ask to see your cell design. I'm having trouble getting good output from my cell. It's 11 plates from lowes, one pos and neg with 9 neutrals in between. ran it at 22v dc at 3.5 amps, and got 1/4 l per min. I thought I should get more than that! everyone I talk to says to have 2v dc between each plate with .25 watts per square inch of surface area! Can you help me out there?
This one was a commercially built plate system. (basically a Smack's cell knock-off)
Center fed with 2 current paths. Each path had 3 or 4 active gaps (same as the later Smacks cells)
Getting any cell to perform is a careful balance of plate surface area, electrolyte concentration, careful management of current flow and heat management.
Hi, I have to ask to see your cell design. I'm having trouble getting good output from my cell. It's 11 plates from lowes, one pos and neg with 9 neutrals in between. ran it at 22v dc at 3.5 amps, and got 1/4 l per min. I thought I should get more than that! everyone I talk to says to have 2v dc between each plate with .25 watts per square inch of surface area! Can you help me out there?
Cheers
dbrannon79 3 years ago
This one was a commercially built plate system. (basically a Smack's cell knock-off)
Center fed with 2 current paths. Each path had 3 or 4 active gaps (same as the later Smacks cells)
Getting any cell to perform is a careful balance of plate surface area, electrolyte concentration, careful management of current flow and heat management.
lutherp40 2 years ago
amps?
asusreviews 3 years ago
See the link to the PDF data file in the "More Info" section of this video.
I hit 4.6 MMW at 11.35 amps, and again at 18.40 amps.
lutherp40 3 years ago
nice job!
mdpollok 3 years ago
super production!
thecellinside 3 years ago