I’m trying to control a four-wired hard-drive motor I extracted but I haven’t found any good information, could you please tell me a little bit more about your project(Schematic PLEASE) any information would be appreciated
The motor is a 3 Phase, 4 Pole permanent magnet motor wound WYE style with a center tap (not used). The three arms are driven through a L293D dual reversible motor driver with one of the outputs not connected. One of the arms is held at ground while the other two alternate states with increasing frequency. It is a really simple setup and could be reproduced with almost any micro controller. The project was abandoned because the motor barely produces usable power and is just a test.
it sounds like a plane
TheSupertecnology 6 months ago 2
mi può elencare i componenti?
youpcworld 7 months ago
Is it just me or is the sound of the motor, well on the lower pitch, nice to hear?
nightfoxx26 7 months ago
Very cool!!
DJHxCxK 10 months ago
I’m trying to control a four-wired hard-drive motor I extracted but I haven’t found any good information, could you please tell me a little bit more about your project(Schematic PLEASE) any information would be appreciated
jose1791 10 months ago
ha sharpen the disk andu got a weapon
itzjoeyppl 1 year ago
This has been flagged as spam show
look at this video
youtube.com/watch?v=wfqOUb_CyJ8
cedovem 1 year ago
sounds like it gets at least 10k to 15k rpm
the731272 1 year ago
The motor is a 3 Phase, 4 Pole permanent magnet motor wound WYE style with a center tap (not used). The three arms are driven through a L293D dual reversible motor driver with one of the outputs not connected. One of the arms is held at ground while the other two alternate states with increasing frequency. It is a really simple setup and could be reproduced with almost any micro controller. The project was abandoned because the motor barely produces usable power and is just a test.
kevlar429 1 year ago
please provide schematic and source code. i've seen thousands of demmos but nothing concrete.
Moty23m 1 year ago
You're gonna hurt yourself on that thing!
YouBetterThinkAgain 1 year ago
great job !
idcroldsoft 1 year ago