Hirobo SDX 50 3D Flight

[azndrumma69]

@bbq4good

Its been a while since i've had this model. But from memory i think i was running something around 12+- pitch and 8+- cyclic.

[GTRwill4everLEAD]

ok , you have past your helicopter license

you can now fly

[nickosmal]

the power of your servos is enought for 3d?did you have any stalls about power of your servos....or is ok?because many people says that is not so big power the 6.6 kg sevos for hard 3d.....please reply.....

[azndrumma69]

@nickosmal

Yep its plenty mate. Theres alot of assumptions today that you need rediculous servo's to fly good. Over the years, i've found that if a servo has over 6kgs torque and faster than about 0.17 seconds then it is sufficient for anything. Hope this helps some :)

[1995e1998]

cut grass



[goodsign8]

Awesome technical fly! May I ask one question can it uplift a canvas bunting 2' x 8' dimensions? This is for ad biz management purpose and thank you in advance for the answer that would be provided.

[3dman34]

Asome flight man

[azndrumma69]

Non SB radix blades. Stock hirobo paddles with both weights.

[munch003]

Nice flight.

Very consistent headspeed.

May I know what is the setup

for the paddles and

are the RADIX SB's?

[azndrumma69]

Setup is as follows:

OS 50 engine

Funtech pipe

Radix blades

Hitec 6965 servos

Revlock 30 governor

Thanks

[joecarnine]

Can I know your heli setup and equipment.?

Like Engine, Muffler, Governor etc...?