@DrDiatone You can get every type of cable through Newegg. Check your USB card to see what type of power connector it uses. Many new cards need a Molex type connector so you might need an SATA adapter or Molex splitter depending on how you set up the server.
All are good, but I'm having difficult time in removing the static cable from the board. It has a small metal clip and I snap them to remove, but it doesn't help.
I'm unable to remove the tray becasue of that stupid cable, any help?
@macintosh0 I have two of these and do not make noise at all and they are very quick.
for the front 4 bays you do not need any cables or power as it is in a slot mechanism however you will need a SATA cable for the top 5.5" bay and the appropriate connectors.
For me I added a 3.5" SATA drive so i need a sata cable and also a molex to SATA power connector.
This has been flagged as spam show
Nice video!!!
Can you do a video about how to install a low-profile graphic card to the Microserver!? THANKS!
flyme2japan 3 weeks ago
Comment removed
flyme2japan 3 weeks ago
Where can I get the cable(s) to bring power to the USB 3.0 card, both with/without an optical drive in place?
DrDiatone 1 month ago
@DrDiatone You can get every type of cable through Newegg. Check your USB card to see what type of power connector it uses. Many new cards need a Molex type connector so you might need an SATA adapter or Molex splitter depending on how you set up the server.
jpltim 1 month ago
Nice video but is it really necessarily to show or drink a beer while you are doing this?
designwebs 1 month ago
All are good, but I'm having difficult time in removing the static cable from the board. It has a small metal clip and I snap them to remove, but it doesn't help.
I'm unable to remove the tray becasue of that stupid cable, any help?
sreenathgotur 2 months ago
Comment removed
supajonesy 8 months ago
What was the model of the USB 3.0 PCI card you used?
supajonesy 8 months ago
@supajonesy Amazon# 216376498 Cavalry 2 Port USB 3.0 PCI-E Host Card
jpltim 8 months ago
45 decibels at the front and no vibration. It has four drive bays and no additional cables are needed for those four SATA bays.
jpltim 9 months ago
Hey.
Does this server make a lot of noise/vibration?
Also can you put in an new HDD or Do you need cables for that?
Thank you very mutch :-)
macintosh0 9 months ago
@macintosh0 the HDDs will fit into the bays you will not need additional cables.
angeloedades 9 months ago
@macintosh0 I have two of these and do not make noise at all and they are very quick.
for the front 4 bays you do not need any cables or power as it is in a slot mechanism however you will need a SATA cable for the top 5.5" bay and the appropriate connectors.
For me I added a 3.5" SATA drive so i need a sata cable and also a molex to SATA power connector.
angeloedades 9 months ago