decent video although as a trained machinist and cue repairmen I use different methods. 500 RPM's I believe is a little slow and I like to cut toward the end of the tip with a razor knife when flushing the tip to the ferrule. Still, it is a pretty good video for someone who might wonder how the job is done.
what can i use to burnish my tips .a cue maker put some sort of waxs on on its realy hard
1120adrian 10 months ago
what should i use to brenish the tips
1120adrian 10 months ago
I have a little question. Do you make new collets to diffrent types of cues, or it fits to most of them?
lextorn92 1 year ago
You cut off the old tip with a razor blade much faster ( by hand ).
joeygonzo 1 year ago
@xEvil8x A plastic collet.
KamuiTips 1 year ago
Way too much sanding at the end. That ferrule will look like a bullet after about five tips.
wildwing1955 1 year ago 3
decent video although as a trained machinist and cue repairmen I use different methods. 500 RPM's I believe is a little slow and I like to cut toward the end of the tip with a razor knife when flushing the tip to the ferrule. Still, it is a pretty good video for someone who might wonder how the job is done.
deltadon100 1 year ago