chick 99936 any bolt mounting into the engine block and exhaust manifold, you need to use "high temp" thread lock. Its for this particular application. Do not use blue or red threadlock it wont work it will only melt.
hi i have a question i have a baja 5b and the problem im having is my clutch keeps sticking to the clutch bell makeing my baja keep moveing could the clutch be to big its a high respones clutch wit spring its cy motor are all the clutches the same size 5b rtr and 5b ss please help if can?
@mumforddale You need to turn down the LOW speed needle, to a rpm that you like. Try turning the Low speed needle down until the engine bogs and dies, the lean it out about 1/16-1/8 of a turn.
It starts and idles just find But goes about 7 inches and makes a popping noise and rolls another 7 inches and pops again what do you think?? Thanks
Shyhighable 4 hours ago
My 23 cy Fire Hammer is making a noise not started if you push it a little it makes a popping
noise under the housing my diff. Are Good what do you Think??
Shyhighable 4 hours ago
chick 99936 any bolt mounting into the engine block and exhaust manifold, you need to use "high temp" thread lock. Its for this particular application. Do not use blue or red threadlock it wont work it will only melt.
Leathernecks63 1 week ago
when you put the engine back together do you need to use any thread lock on any of the bolts
chick99936 1 week ago
Shit I stripped the bolt at 4:40. It's was IMPOSSIBLE to remove. The wrench was twisted as hell and the bolt stripped
Damino95 1 year ago
You are going ahead of youself!
Dareeude 1 year ago
Im looking to get my first 1:5 scale. Im looking at either the 5B or 5T. Any suggestions on what would be a better buy?
Mahaney82 1 year ago
@Mahaney82 Both are the same chassis and same engineect. the only difference is that the 5T has different wheels and tires and boddy mounts.
ghp020 1 year ago
@ghp020 Well I guess it all boils down to looks at that point. Hahahaha. Thanks.
Mahaney82 1 year ago
hi i have a question i have a baja 5b and the problem im having is my clutch keeps sticking to the clutch bell makeing my baja keep moveing could the clutch be to big its a high respones clutch wit spring its cy motor are all the clutches the same size 5b rtr and 5b ss please help if can?
mumforddale 2 years ago
try idling it down
mower26 2 years ago
@mumforddale join the HPI Baja Forum its the best for advice. Im a member of it too.
bill2032 1 year ago
@mumforddale You need to turn down the LOW speed needle, to a rpm that you like. Try turning the Low speed needle down until the engine bogs and dies, the lean it out about 1/16-1/8 of a turn.
ghp020 1 year ago
dude, your the shit for making these videos!
numbr2luder 2 years ago
LOL the subliminal message. Have Questions! 1:23
Xx11HaloGuy11xX 2 years ago