Pretty neat looking, I experiment with this myself, the IRFP260 mosfet gives me good results, but I never have the 555 powered by the same supply as the mosfet, or have the mosfet on the same board as the 555 just in case any kickback from the primary arcs from the mosfet area into the 555 area.
Pretty neat looking, I experiment with this myself, the IRFP260 mosfet gives me good results, but I never have the 555 powered by the same supply as the mosfet, or have the mosfet on the same board as the 555 just in case any kickback from the primary arcs from the mosfet area into the 555 area.
CoolDudeClem 7 months ago
Hi, is very nice!, It's possible to have a schematic and/or a mosfet Part Number?
I wait your news
Thanks
gabdrum23 1 year ago
im not convinced, i wanna see the schematic diagram... besides this is still a video many things could be done.
abzosairis 1 year ago
Can you replace the MOSFET with an IGBT?
GrandpaTD 1 year ago
Wow, thats a high frequency arc! At what frequency are you driving this particular flyback at?
zker666 1 year ago
Comment removed
CyberWalker2004 1 year ago
Comment removed
CyberWalker2004 1 year ago
diagram please
teslanumbertwo 2 years ago
Very nice, you should plug audio on pin 5 .
darkthero 2 years ago
@darkthero
Is it that easy? :D
lilletizz 2 years ago
yep! i made this recently for my senior boards i can send you my schematic, if you like :D
darkthero 2 years ago
Whoa, nice!
You got a email or instant message?
PM me!
lilletizz 2 years ago
nice : -)
can you share your project?
thanks
furqan51 2 years ago
DC??
08Kutt 2 years ago
lol, we've got the same flybacks
SmashCOBamberg 2 years ago
Comment removed
SmashCOBamberg 2 years ago
my voltage supply does nog go higher than 2 amp ;(
zezimashock 3 years ago
Where did you get the flyback transformer?
bartley440 3 years ago
And what freq are you using to drive it?
bartley440 3 years ago
That is always dependant on the inductance of the coil in the transformer (actually of the circuits impedance)
ThingyOtus 2 years ago
i just can't stop watching this XD
zezimashock 3 years ago
you got a schemetic?
zezimashock 3 years ago
awsum
Ztuibyman 3 years ago
Sorry, other stuff: I increased the voltage and with this.. the arcs!
mumish13 4 years ago
I trip and... I can't upload the video.. soon I upload the video.
mumish13 4 years ago
I would drive it higher, but this particular circuit was intended for low-power operation and does not use a 7812 regulator for the 555.
derekaggs11 4 years ago
Your flyback driver is feeded with 13.5 vdc? Soon I upload a video of my flyback driver
mumish13 4 years ago
I have the frequency set a bit high here; if I tune it down to 17 kHz or so, the arc starts at 1.2 cm at this input voltage.
derekaggs11 4 years ago
I maked a similar system, but the MOSFET is changed with a IRF830. in 7 volt the arc have 3 1/2 mm of lenght.
mumish13 4 years ago