Connect Your Xbox 360 To Your Mac!

[asadali9091]

wait wait wait wait dude what the fuck is the point of doing this lol?

[elijahpr]

@asadali9091 Well, I did it because I didn't have an ethernet cable that would reach all the way across my house, nor did I have a wifi adapter for my 360. That's basically what this does.

[whumbo7whale]

would this still work if your mac is on wifi? and then you try connecting your xbox with the ethernet cable? also if it does work on with my computer, would i hav to switch the settings if i plugged my xbox into a different ethernet cable?

[elijahpr]

@whumbo7whale Yes, my laptop was on WiFi while it was working.

[lukeyfarah]

can you take out the plug

[joorgee713]

it works!!!!!!!!

[chrismcnaney8]

i have looked at like ten webpages and four videos and yours was the only one that worked....thank you so much you wonderful man....

[snipe2531]

why did you buy a mac? lol

[Forgon2]

I needed to say, that your was the only video that actually worked for me!! Thank you very much! I appreciate it!

[swendi]

dude your the fucking man

[alexmanzo01]

wtf do you mean by take a note of it?

[TheCatchpenny]

@alexmanzo01 Write it down, and use that number. Your numbers might be different than his, so take note of it, and use YOUR numbers.

[alexmanzo01]

@TheCatchpenny thanks man i did it a long time ago but thanks for answering:D

[TheHDAstro]

is this faster than i wireless addaptor?

[elijahpr]

@TheHDAstro I would say no, because you have to use your computer to connect, where as an adapter is a direct connection to your WiFi. But, I could be wrong, and it also depends on your internet.

[ThMaggotUtube]

@elijahpr i would say it's about the same. You don't lose speed through an ethernet

[Archiej1121]

YOUR THE FUCKING MAN

[PhsycoSleivert]

THANK YOU! can i please get your adress so i can come and suck your dick?

[sarvaia]

THANK YOU SO MUCH I HAVE LOOKING ON HOW TO DO THIS FOR AGES!!!!!

The only bad thing is that you either get moderate or strict nat settings... know anyways on how to change that?

[elijahpr]

@sarvaia Try opening the NAT on the router you use. Mine were strict, and went to moderate when I did this. I'm not sure how to open it all the way though. If you figure it out please post it on here and I'll add it to the description.

[elijahpr]

Try restoring all your network settings to default and resetting your router/modem, then set it up again and see if that works.

[DustyMotherboard]

@elijahpr dude how come in ur terminal it says active under status, mine says inactive, how do i make it active?

[Stevsta1213]

i did everything you said, and it used to work in the past,. but now when i try to connect to test the connection it goes up to network, then wont connect..