Hi. Just click on the down arrow to the right of "Show more" and you will see the how to do information.
All you have to do is press and hold the DISP (Display) button per instructions on Page 70 of the TS-2000 manual. This will work for the Main or Sub Receiver.
Memory VFO/M and SCAN buttons must be off.
The scope show sigs that are S9 or stronger. S3/S5 sigs are possible. The limit is due to the resolution of the square "pixels" of this type LCD display.
We all would prefer larger display but when you realize that S9 or greater peaks show, you can use it to slide & select any of these stronger signals from this display. For less than S9, you have to use just your ears unless you have an expensive external solution. From the perspective that it was included in the rig for no extra cost, it's great. It is not in the TS-590 by the way.
Hi Andy. All you need to do is to press and hold the DISP (Display) button. This is for the main HF receiver. If you have your sub receiver turned on and it is scanning, stop that scan first, then go back to Main receiver and press/hold DISP until you see bandscope sweep start. To stop sweep but still display, briefly press DISP. Now you can spin VFO knob and you will see a blank pixel move on the scope to show position relative to peaks. Try on 20m today w contest activity. Max RF gain
hi
can you re do the tube on how todo the band scope ?
102at101 6 months ago
Hi. Just click on the down arrow to the right of "Show more" and you will see the how to do information.
All you have to do is press and hold the DISP (Display) button per instructions on Page 70 of the TS-2000 manual. This will work for the Main or Sub Receiver.
Memory VFO/M and SCAN buttons must be off.
The scope show sigs that are S9 or stronger. S3/S5 sigs are possible. The limit is due to the resolution of the square "pixels" of this type LCD display.
radioguyk7 6 months ago
We all would prefer larger display but when you realize that S9 or greater peaks show, you can use it to slide & select any of these stronger signals from this display. For less than S9, you have to use just your ears unless you have an expensive external solution. From the perspective that it was included in the rig for no extra cost, it's great. It is not in the TS-590 by the way.
storyoilco 11 months ago
Hi Andy. All you need to do is to press and hold the DISP (Display) button. This is for the main HF receiver. If you have your sub receiver turned on and it is scanning, stop that scan first, then go back to Main receiver and press/hold DISP until you see bandscope sweep start. To stop sweep but still display, briefly press DISP. Now you can spin VFO knob and you will see a blank pixel move on the scope to show position relative to peaks. Try on 20m today w contest activity. Max RF gain
storyoilco 11 months ago
Hi there!
Nice video after owning a TS2000 I never knew it had this feture!
How do you make it work?
Cheers
Andy, 2E0OJE
2E0OJE 11 months ago