This was the first and only time going this deep, just seeing what it could do.
It shouldn't miss steps though as it was only running @ 4IPM. Would be getting the most torque out of the motor at this slow speed. At .250 deep it hardly strained it at all so I would run at that depth normally.
Hi Hoss, like your vids.
when you take those big depth of cuts
do you have any lost steps?
NovaStar77 2 years ago
This was the first and only time going this deep, just seeing what it could do.
It shouldn't miss steps though as it was only running @ 4IPM. Would be getting the most torque out of the motor at this slow speed. At .250 deep it hardly strained it at all so I would run at that depth normally.
Hoss
hossmachine 2 years ago