Structure of The AFW Ring

[TheAlejandroleo]

what did u use 2 hold the turnbukle and the post

[spiritjd33]

@TheAlejandroleo I used screws to hold onto the post, the post had flat plates welded to them and I just pre drilled holes onto the plates and screwed the screws to the board and throught the holes

[TheAlejandroleo]

@spiritjd33 how did you make the yellow turn buckle stick and is the thing holding the ropes paperclips

[spiritjd33]

@TheAlejandroleo I used the electric tape I was using. when laying it on the thing you're using for the turnbuckle pad, make sure to leave the piece longer then the pad and then cut tape parallel length in the middle. The cut is for the wire or paper clip

[EWEstopmotionX]

dude what do u use to make the ropes??????????

[spiritjd33]

@EWEstopmotionX I either used string, yarn, or little rope and wrapped them with electric tape

[DangerousChemicals31]

are the pads on covering the turnbuckles velcro?

[spiritjd33]

@DangerousChemicals31 nope, the pads are can be made either out of aerobics mat or packaging padding

[DangerousChemicals31]

@spiritjd33 Would Velcro work??

[spiritjd33]

@DangerousChemicals31 I think it would, never actually tried velcro before

[DangerousChemicals31]

@spiritjd33 Thanks man. I will sub you,

[CKYZOCKER]

Nice

[spiritjd33]

I just noticed, I commited a location fail

[chipsofunny101]

thank you

[spiritjd33]

probably took a long time but managed to make a vid