Bill: Your website says 154 tooth flywheel, and in the video you say 153. Next up: in the video you say it's for the wide block only, can this be used for the narrow block (1g dsm 6 bolt) 4g63's? What all is included in the kit? I sent you an email Tuesday, and didn't hear back from you yet. Please comment.
On your website Bill, it says that you use a 154 tooth flywheel, just a heads up. Anyway, couple questions. What are the part numbers for the flexplate and starter you got from Jegs. You say in the video that this is only for wide blocks. Are you saying that this can NOT be used with the 4g63 narrow block Mitsubishi engine? (6 bolt)
Bill: Your website says 154 tooth flywheel, and in the video you say 153. Next up: in the video you say it's for the wide block only, can this be used for the narrow block (1g dsm 6 bolt) 4g63's? What all is included in the kit? I sent you an email Tuesday, and didn't hear back from you yet. Please comment.
90laserRSfwd 3 months ago
how much for a setup? what years and type off tanny will it support?
Mrinfoone 10 months ago
you mean I can finally hook my 4g63t to a turbo 400?! finally, a tranny that can handle this angry powerhouse!
bleachworthy 1 year ago
@bleachworthy correction- just noticed whis is a 4g64 :(
bleachworthy 1 year ago
Looks like a turbo 250/350 trans...do you thing a t5 from a camaro would work?
Denton15501 1 year ago
On your website Bill, it says that you use a 154 tooth flywheel, just a heads up. Anyway, couple questions. What are the part numbers for the flexplate and starter you got from Jegs. You say in the video that this is only for wide blocks. Are you saying that this can NOT be used with the 4g63 narrow block Mitsubishi engine? (6 bolt)
90laserRSfwd 1 year ago
13 mm is just slightly larger than a half-inch.
headoverseer 1 year ago
buen trabajo viejo sos un jenio
leormdr 1 year ago
money in the bank, lol great vid Bill.
screwwed 2 years ago
nice fab. work. "If you can think it, you can build it." NICE !!!!!
mustangpapi76 2 years ago
how much for the kit
FIZtheWIZ 3 years ago
how much for the kit and where can i buy one?
sidewaysstarion 3 years ago
seriously where the can i get one!
Eclipsetuner 3 years ago
Go to your local machine shop I could easily make that with a CNC its so easy it would make you laugh 15 minutes worth of work
arabrockerman 2 years ago
wow bill
beefkake25 3 years ago