Banks exhaust on jeep wrangler

[kddcc]

a noticeable differance on the road?

what about mpg?

[andrewsvids]

@kddcc ya. i could notice it. i didnt notice mpg change. itll go down normally because your always on the gas to hear it. it really made a difference with my air intake

[domeslacker]

how is the sound inside the cabin. i just bought the header and cat back from banks. havent put it on yet. is the sound really loud inside the cabin?

[andrewsvids]

hey, it is actually really nice inside the cab, you can hear it and know its there, but it is a good sound. its a nice grumble. i dont have the header though, this is just the cat back

[RockinCrawler]

Hey Andrew, Nice exhaust you will like it!! I have the same except mine was exhaust manifold and all, I'm getting ready to stroke my motor, I'm excited about that!! Well Take care & get more vid's of your Jeep!!

[andrewsvids]

im about to post a video of it with an air intake and throttlebody spacer added offroad

[andrewsvids]

@RockinCrawler hey i bought headers now but the only problem is i cant find a place do get them installed for under 500$. where did u get urs installed or did u do it urself?

[joepowles]

@andrewsvids I just swapped out my headers by myself. If you have the tools i would suggest it. Going to need 10, 13, 14, and 15 mm sockets a few different extensions, an u-joint, and of course a ratchet :) I took everything off myself in maybe 2 hrs then a friend came and helped me put everything back on. took about 4-5 hrs total. I think it's worth every bloody knuckle to work on your own jeep. builds pride and you'll know how to fix it when it breaks.

[andrewsvids]

@joepowles yea im gonna do it this weekend with my dad. did u use a fuel rail disconnect tool?

[joepowles]

@andrewsvids No i didn't have access to one. If you can find a piece of plastic about the right thickness you can wrap it around the fuel line and slide it in to disengage the clips. I used a razorblade and cut a piece out of a CD spindle cover. The tool will make it alot easier but there are ways around it. Could always take a 1/2 in open end wrench put it over the line and hammer it off. then bend the pins back. done that before too, run the risk of them breaking tho : /

[sunbakd1]

because I could not hear that much of a difference. Maybe it was the camcorder or just my hearing is going bad.

[sunbakd1]

hope that did not cost more than a couple hundred bucks.

[andrewsvids]

200

[andrewsvids]

yea but compared to the rest of exhausts u you could get for the wrangler this was the most power... but anyway the sound really kicks in at 3000 rpms