DynoJet Jet Kit Install VTX 1300 - Video - Cruiser Cusotmizing

[TheJkinne]

You must be kidding! You need to remove the entire carb to get at the back two bowl screws! I've been DUPED into purchasing your product, and now I have a brand new bike half ripped apart! Shame on you guys!

[heroes91092]

@TheJkinne Sorry to hear that man. I know where ur at though. My bike is all tore apart right now too cuz I need to clean the carbs. U might want to do that too while ur at it

[velhonen]

I hate that black rubber... :/

[dossen2620]

I have a hard time getting to the back 2scres on the float bowl. I have a shadow aero 750

[freakof84]

is this the same on a vlx 600

[kopynd]

explanation was quite clear, I own the wildstar 1600, I have replace my ehaust system, to vance hines long shots, I did not need to rejet. When I changed the stock air filter to a megga chrome piked, than rejeting had to be done, there is a chance of a melt down on the valves and pistons, so buy the kit. the bike in the video looks quite new, my advice is when you remove the screws in the float bowl cover , renew with allen bolts,

[gt2nv]

looks good other than you forgot to clip the tip off of the cap before reinstalling the needle and you should have drained the gas out of the bowl before you took it off. that will keep gas from going everywhere.