Bedini Running another Bedini

[333kgb]

The negative on the primary battery go’s to the inner 20 gauge wire on the coil which also go’s to the emitter on the transistor and the inner 24 gauge wire from the coil go’s to the collator on the transistor then the neon bulb is connected to the emitter and collator does it matter which way I put the neon bulb? And is there any problems you see in this hookup? I noticed when I put a drill bit in the coil it shoots it out and my core is made of drill bits. help!

[Lidmotor]

@333kgb -----No. There is not polarity on the neon. I used quik setting epony resin to hold the metal core (small nails) together.

[333kgb]

The potentiometer is connected to a 24 gauge outside coil wire. My 1N4007 diode is connected to the positive on the secondary battery. Then the outside 20 gauge wire runs to negative on the secondary battery and on the positive on the primary battery.

[333kgb]

Nice video! Hi I have been trying to get the bedini motor to work, but the wheel just comes to a stop. My setup is 1N4001 diode is connected on the emitter to the base on the transistor. Then the base is connected to a 470 resister. Then resister is connected to the potentiometer.

[MrJetjoe]

run time must be greater than charge time.= free engery

[MrJetjoe]

your exp. are too small and not enought power to make power. batterys are fuel overunity is realty. use moter rateings the right way. cheers

[jembalangmerah]

lidmotor, i'm having problem wif the supcaps.i'm using maxwell 140F caps as the 2dary part. I manage 2 get 2units of them.then connect them in series to get 5V & 70F.however, my bedini does not charge the two caps.I thought my circuit could have go wrong. I tried wif caps 2200uF,16v&they charge pretty well.

I tried charging 2 units aa size nickel hydrite & they are charging.

I only know that they hav low impedance.

Is there anythin else I should know bout the supcaps features?

[Lidmotor]

I am still learning how to best use these super caps on a Bedini. The ones I have work on either side of my low voltage SSG. Before I tried them on the motor, I experimented with them by charging them up with a battery and discharging them thru either a light bulb or a small motor. I used my volt meter and watched the results to get a feeling of what they would do. Your 70F cap is going to charge up very slowly on the Bedini. Mine are 20F.

[jembalangmerah]

Thanks man,really appreciate ur info =)

[jembalangmerah]

lidmotor, is it possible to use supercaps to replace both primary and secondary battery to run the motor continuously??

[Lidmotor]

Hi, Good question about using supercaps on both sides of the Bedini SSG. I don't know. I didn't see any signs that a supercapacitor could capture the energy like a lead acid battery. The true design reguires using lead acid batteries to work the way that John Bedini designed it.

[jembalangmerah]

Lidmotor,is it possible to use supercaps to replace both primary & secondary battery?

If we parallel the secondary supercaps with celpone charger,is it possible to charge our celphone?

[Lidmotor]

Yes. You can you a Bedini SSG to charge cell phone batteries. Check out rayOenergy's videos on how to do it.

[marthale7]

Daftman Rocks! :) I have many good ideas that work from him.

[Lidmotor]

The man knows what he is talking about.