HHo - setup for my scooter

[alexphone32]

hello, in my hho sys in also install map and efie which one should i adjust first.. would you please tell me sir..thank you at (((xinlex@yahoo.com)))

[dreamyear]

is that coil for buck converter ? how many voltage dose it go upto 

[poprock4me]

@dreamyear the ouput volts release is not stable from buck converter , but the

output i saw is 8.82 amps maximum, perhaps it depends also the design of fuel cell , irondmax said should try a different way inductor for pos. and inductor for neg. but i make only on pos.

[irondmax]

@poprock4me

output volts depend on cell design. and input volts.

amps depend on electrolite and cell design.

pulsed wattage is limited by the frequency and size of the coil.

buck converter is for limiting wattage.......

boost converter will raise voltage.......

for a boost you need to move the relay to between the cell and the inductor.

[poprock4me]

@irondmax  thank you max

[irondmax]

there are many ways to wire the inductor.......if you wire the pos through....then wire the pos through the other way.......only the pos runs though the inductor....both coils.......... it adds capacitance and no magnetic field in the steel core.....there will be more bubbles in your cell. i am sure the neg will do the same... then we have 2 inductors....

i think a pancake coil will do it without the steel core

talk to you later

[poprock4me]

@irondmax thanks max  i add another knowledge to you , i use positive inductor and straigth wire to negative , i know there will more amps come out because the magnetic fields are very strong , my fuel cell design is not good , i will try my fuel cell plates , i know there will be more amps increases .

[irondmax]

@poprock4me

try this......if you windings are equal and sise by side.....pos wire goes to the other side then connect wire to the wire going the other way......neg to cell ..this will cancell the magnetic field and add capacitance......your hho production will increase, and magnetic field in the inductor will be zero .

increase your amps by your electrolite......inductor HERE, limits amps.....does not make them......slows them down.

[irondmax]

it is alive.......

is it working ok?

did you make it from my video post?

make it yourself?

[poprock4me]

@irondmax  yes max its alive , i make all this circuits from your video post

and all is working good . thanks max

[vox1philippines]

hehehe.... malapit na !!!

[poprock4me]

@vox1philippines  vox buena mano ? buenas diaz amigo .

[vox1philippines]

@poprock4me astalabistas !!! walanabang tulugan?

[poprock4me]

@vox1philippines meron pa akong ina upload , after tutulog narin .