CZ 452 22lr & HMR RIMFIRE RIFLE BOLT CLEAN & LUBE.

[1347channel]

brunox is one of the best sprays of this planet.

[canidoodoo]

this guy need to start a new job read kidz bed time storys they would b sleep in no time

[AngeredKabar]

If you can get your hands on some break cleaner it works very well for cleaning without completely disassembling anything. You must give everything a light coat of oil afterwards because the break cleaner strips all traces of oil, leaving steel unprotected and able to rust easily.

[gunvidder]

@AngeredKabar Used for cleaning silencers as well. Good but expensive.

[WSGAC]

Why don't you just disassemble the bolt and bypass oil spraying everywhere. Disassemble is easy and quick.

[gunvidder]

@WSGAC I know I know but this is less fiddly & a quick flush & lube is easier than a stripdown every time I use the rifle. I don't spray everwhere, with a delicate finger control I just coat the outside & flush the inside, any run off is collectected to use as lube for lathe turning.

[Jrhoney]

Petrol works for cleaning if you cannot locate a proper gun solvent. Then oil it with a good gun oil or really lightweight oil.

[gunvidder]

@Jrhoney Petrol is a good alternative.

[ffnovice7]

So, I've heard that the cardinal no-no of solvents and lubricants is WD-40 because it leaves a gummy residue at very high temperatures (after firing).

.

Does your Brunox get rid of the problem entirely, or do you find some trouble still?

[gunvidder]

@ffnovice7 Not noticed anything like that with Brunox, I've also got a can of Napier, I'll have to give that a tryout.

[TheHiddenPart]

nice video. I prefer using both WD-40 and an old toothbrush to really scrub dirt off the extractors channels & ejector channel.

I've cut it to size as to reach into the extractors recesses into the breech, and give a nice rubbing to the bolt rails.

[gunvidder]

I do this before putting the rifle away in the cabinet while everythings still soft.

The toothbrush is a good idea.

I'll look around for a bigger container for the overspray to drip into (I use it as a lathe work lube as well) so I can dip a toothbrush into, yes a good idea.

Thanks.