RX-7 Bee-r Rev Limiter

[zbabar3000]

will this still work for an automatic?

[blackenrotary]

how do u install?



[eletor]

2k rpm will be a good point to launch from

[knduong]

Got a video of the exhaust shot while doing this?

[flomracing]

@knduong sorry, bought another rx7 and took it out to install in the other, its not currently installed on either. 

[knduong]

@flomracing sweet, I just wanted to see some flames :D

[xXcuzoXx]

thats stupid, you cant even launche a Rear wheel drive car at those Rpms...

[flomracing]

@xXcuzoXx You are retarded....you can adjust the rpm up to 10k for launch, I was just testing it...you don't test it at the rev limiter...

[Tj1056]

@xXcuzoXx yea 2k is basicly driving off... 3k is perfect launch... :p

[Leftthefear]

s4 or s5?

[flomracing]

S5 1990 GTUs

[nochugare]

how do you install a bee r rev limiter into an rx7? i cant figure it out on mine cuz i cant find the right pins. i have an s5 rx7. if you have any info on how to do it. it would be very helpful.

[flomracing]

It cuts the spark from the ignition as opposed to the fuel (as in stock rev limiters) which can cause a lean condition and detonate. Don't run one of these with catalytic converters (you should know better) as it will likely melt its core and plug the exhaust. Its intention is for spooling a turbo under no load for launching without turbo lag by letting the fuel enter the exhaust to ignite, thus spooling the turbo. but its a 2 step rev limiter meaning you can set launching revs and rev limit.

[polinimotori]

I had intended to buy one before...

[polinimotori]

this system will damage your engine or protect?

[maxpower700]

Depends on HOW you use it and for how long =)