Yeah safety tip: if you're cutting wood, especially with power tools, WEAR SAFETY GLASSES/GOGGLES. A splinter in the eye is no joke and no fun. Otherwise, cool video!
Matchgirl42 2 weeks ago
if the middle was sealed with 1/3 of the middle covered the air would be presureized more causing more lift thus higher
TheGemmaster22 1 month ago
Is the linkman a bit stupid ?
Myhok 1 month ago
goggles?
woodsandworkshop 4 months ago
if holes were in the plastic you would go higher
zbeast97 6 months ago
kool mannng...
vangbro920 6 months ago
check out my complete instruction on building a hovercraft - with 3d modelling
engineeringdotcom 8 months ago
magnificent
treridings 11 months ago
can it go over water ???????????
Icecube5285 11 months ago
adult supervision how supid do you think i am?
briggs4life1 1 year ago 2
This guy should read a book. 6 mm plastic? that's about 1/4 inch thick. This plastic is 6 mil (0.006 inch) thick.
rmhayes1954 1 year ago
dope
sketchartist88 1 year ago
Yeah safety tip: if you're cutting wood, especially with power tools, WEAR SAFETY GLASSES/GOGGLES. A splinter in the eye is no joke and no fun. Otherwise, cool video!
Matchgirl42 2 weeks ago
if the middle was sealed with 1/3 of the middle covered the air would be presureized more causing more lift thus higher
TheGemmaster22 1 month ago
Is the linkman a bit stupid ?
Myhok 1 month ago
goggles?
woodsandworkshop 4 months ago
if holes were in the plastic you would go higher
zbeast97 6 months ago
kool mannng...
vangbro920 6 months ago
check out my complete instruction on building a hovercraft - with 3d modelling
engineeringdotcom 8 months ago
magnificent
treridings 11 months ago
can it go over water ???????????
Icecube5285 11 months ago
adult supervision how supid do you think i am?
briggs4life1 1 year ago 2
This guy should read a book. 6 mm plastic? that's about 1/4 inch thick. This plastic is 6 mil (0.006 inch) thick.
rmhayes1954 1 year ago
dope
sketchartist88 1 year ago