@ihatewii1 Hi mate. Because the new gearlever is slightly lower than the original, the bottom of it needs to move left-right slightly. Without the ability for the rod end to slide along the shaft, it's impossible to select gears as the whole assembly binds.
nice but why so much slop in the rod end bearing on the axis?
ihatewii1 1 year ago
@ihatewii1 Hi mate. Because the new gearlever is slightly lower than the original, the bottom of it needs to move left-right slightly. Without the ability for the rod end to slide along the shaft, it's impossible to select gears as the whole assembly binds.
AustImages 1 year ago