Messer Delta Contour Bevel Head with HPR400 plasma

[kentarjoon]

I love watching these Plasma Robots

[vietnamesedude123]

bevel with landing only works with small jobs. part will be moved if you cut a long strip.

[gabbyj666]

What a putz, this part has a 45 degree bevel on it! BEST MACHINE WORLD WIDE KIDS! did you check those consumables?

[srgilleland]

I strongly disagree with muppet. I've personally cut +/- 50 degrees with the HPR260 on a similar Messer machine. The performance was awesome. And the cost of consumables is cheap compared to the lifetime. If you were having problems with consumable life, then you had some problems that should have been addressed.

[muppet1971]

Had expirience of a similar Messer machine but with HPR360 power source. In a word, Rubbish. The machine only cuts +/- 35 at best, and very expensive consumables.