@thebestofindica Yes the one that came with the kit. A little bit of drone under heavy throttle with a trailer behind the truck but nothing at cruising speed.
Your demanding ALOT more fuel that the stock system can supply. An aftermarket lift pump and a free CP3 mod will fix that. Seeing as how this is just a DD that my wife drives most the time and the weekend tow rig for teh pulling truck. I'm happy were I'm at. LOL
How is that? The factory lift pump wont keep up with teh fuel demands of the CP3 with a SMARTY or a Bully Dog turned up all the way... Get a rail pressure gauge if you dont belive me. My truck pulls stronger on 5 then it does 7 or 9. Sure 7 and 9 have a harder intial burst but as soon as it uses up its initial "reserve" supply and drops the pressure... Its a dog. Run it on 5 it pulls strong the whole time. 9 puts down a higher number on the dyno but 5 runs better on the street.
Why would you want to increase the pressure on the fuel rail to inject more diesel and cause thick black smoke? It doesn't give you any more power, it gives you LESS as the diesel is going off as smoke. This ruins the diesel pump, rail and injectors. It's usually people that know nothing about engines that buy this junk after reading misleading advertising. Waste of time, improve performance by taking it off! Feel the difference with a correctly running engine.
right... Thats why its been like that for 80,000 miles and the factory 310 HP engine is putting 450Hp to the rear wheels... This aint no damn gasser... Go pound sand...
runs the rails dry??? you mean it sucks so much fuel the pump can't keep up? then get bullydog programmer the high they put out is the level 5 setting of a smarty and there are on 9.
@cummins143 I wouldn't they are hard to program i've heard the ecm's arnt' big enough the 3rd gens have a bigger ecm and program lot easier you'd be happier with an Edge box
i got the smarty and put it on my 2003 ram 2500 and on sw#1 and sw#3 i get no smoke it just halls ass. now i have a afe stage 2 cold air intake, 4" straight pipe turbo back exhaust and a fass 150gph fuel pump everything else is stock. any one have a clue why i have no smoke
You might try reloading SW # 3. It should smoke if you romp on it. When I got my smarty, I told them to put it on sw # 3, but when I got into it, it didn't smoke, so I went to reload it. It said the current software was sw #4 which should smoke a lot, so just try reloading the desired software.
its a hi performance chip from mads electronics. it plugs in under the dash like a predator chip or hypertech if youre familar with those. if you have more questions just send me a message:-)
im in the market for a cummins myself right now (not buying until i get my license in mid jan but im lookin around and there are a few used 02's isb for sale that i like)
Hows the truck run with it on SW#3? Do you have any problems with the truck?
SpitFire01 9 months ago
is this the tnt or so6?
SockBilly 11 months ago
Are you running a muffler? Is it the muffler that came with the kit? Any drone inside the cab at all?
thebestofindica 1 year ago
@thebestofindica Yes the one that came with the kit. A little bit of drone under heavy throttle with a trailer behind the truck but nothing at cruising speed.
RSWORDS 1 year ago
just because you can, doesn't mean you should. But I like this vid so FUCK IT
anonymous11228 1 year ago
Silverline 4"
This is a crazy old video.
RSWORDS 1 year ago
sounds good, which turbo-back system are you running? MBRP? Sounds a little like my 07 5.9... Are you running a muffler in that setup?
payroll6278 1 year ago
i love ham in my sandwiches FUCKING YEAH MAN YAAAA!!!!@32
mddt711 2 years ago
smarty is hands down the best chip and I agree it runs better on 3 or 5 then it does on 9. Try stacking MP-8 with it... thats a good time.
joeldharrison 2 years ago
aye
Kahlo69 2 years ago
well ok I get it. hope your happy. but whats a CP3?
Kahlo69 2 years ago
The injection pump...
RSWORDS 2 years ago
I just don't see how it just runs dry.... the fuel pump can't keep up then thats sad
Kahlo69 2 years ago
Your demanding ALOT more fuel that the stock system can supply. An aftermarket lift pump and a free CP3 mod will fix that. Seeing as how this is just a DD that my wife drives most the time and the weekend tow rig for teh pulling truck. I'm happy were I'm at. LOL
RSWORDS 2 years ago
my Gasser would tear that thing apart!
obviously, because it doesn't smoke!!
ibow2no1 2 years ago
omg you guys don't understand
Kahlo69 2 years ago
How is that? The factory lift pump wont keep up with teh fuel demands of the CP3 with a SMARTY or a Bully Dog turned up all the way... Get a rail pressure gauge if you dont belive me. My truck pulls stronger on 5 then it does 7 or 9. Sure 7 and 9 have a harder intial burst but as soon as it uses up its initial "reserve" supply and drops the pressure... Its a dog. Run it on 5 it pulls strong the whole time. 9 puts down a higher number on the dyno but 5 runs better on the street.
RSWORDS 2 years ago
Why would you want to increase the pressure on the fuel rail to inject more diesel and cause thick black smoke? It doesn't give you any more power, it gives you LESS as the diesel is going off as smoke. This ruins the diesel pump, rail and injectors. It's usually people that know nothing about engines that buy this junk after reading misleading advertising. Waste of time, improve performance by taking it off! Feel the difference with a correctly running engine.
urbex2007 2 years ago
right... Thats why its been like that for 80,000 miles and the factory 310 HP engine is putting 450Hp to the rear wheels... This aint no damn gasser... Go pound sand...
RSWORDS 2 years ago
@urbex2007
if you fuck like you know about diesel you couldn't git the g-spot on a 90 year old on novocaine!
ibow2no1 2 years ago
runs the rails dry??? you mean it sucks so much fuel the pump can't keep up? then get bullydog programmer the high they put out is the level 5 setting of a smarty and there are on 9.
Kahlo69 2 years ago
And they run the stock rails dry also....
Not my 1st rodeo...
RSWORDS 2 years ago
put that shit on 9
Kahlo69 2 years ago
3 is plenty, every so often i run it on 5, anything more runs the rail dry. All this does is pull teh comp Cummins around, its fast enough.
RSWORDS 2 years ago
i might get a smarty for my 2000 5.9 would u recomend it?
cummins143 2 years ago
YES!
xxlilxxcheadlexx 2 years ago
@cummins143 I wouldn't they are hard to program i've heard the ecm's arnt' big enough the 3rd gens have a bigger ecm and program lot easier you'd be happier with an Edge box
jetman56usf 1 year ago
never liked 4 inch.. i guess if your wanting it to be quiet its ok
x1pyroveride 2 years ago
or if you dont want to lose all your bottome end...
RSWORDS 2 years ago
My 4" hurts your ears goin through a tunnel or under an overpass...
DODGEMEGACAB 2 years ago
my 5 inch can be heard literally miles away.. with no tunnel
x1pyroveride 2 years ago 2
Ya you can hear mine from miles away too, but just hurts to go through a tunnel and have the sound confined.
DODGEMEGACAB 2 years ago 2
is that with the cat?
Jorge50505 2 years ago
no Cat
RSWORDS 2 years ago
i may get smarty for my 07 5.9CTD. hows ya tranny been holding up?
xxlilxxcheadlexx 2 years ago
Holds well as long as you use a little common sence
RSWORDS 2 years ago
well i got the smarty PoD and i love it so much!
xxlilxxcheadlexx 2 years ago
needs a aem brute force cold air intake
dieselvsgas1 3 years ago
Do you have a Smarty Programmer?
ronnybanman 3 years ago
Yeah i run it in my 05. its on sw#4 ,which is the 90 horse, stock timing level. its really awesome the truck just hauls ass.
AntonChigurh1 3 years ago
2006 CUMMINS SMARTY ON SW#3
He probably does have a smarty since it does say CUMMINS SMARTY
thewillylump 2 years ago
smarty is the best for dodge. you can stack a smarty too. bully dog sucks. get it if you want to blow out injector pumps and injectors all the time.
AntonChigurh1 3 years ago
i got the smarty and put it on my 2003 ram 2500 and on sw#1 and sw#3 i get no smoke it just halls ass. now i have a afe stage 2 cold air intake, 4" straight pipe turbo back exhaust and a fass 150gph fuel pump everything else is stock. any one have a clue why i have no smoke
dasanisa 3 years ago
is i a cummins
CUMMINANDSCANIAV8 3 years ago
yes
dasanisa 3 years ago
03 have problems smoking due to the stock injectors are smaller then other years
surfdunn 3 years ago
You might try reloading SW # 3. It should smoke if you romp on it. When I got my smarty, I told them to put it on sw # 3, but when I got into it, it didn't smoke, so I went to reload it. It said the current software was sw #4 which should smoke a lot, so just try reloading the desired software.
kaiserbailey 3 years ago
i have a smarty on my 2000 2500 cummins and when its on stage 3 it blows less smoke then on stage 1 which is fuel saver.... i dont really get that
tcoy13 3 years ago
Sounds pretty good but then again I just love the sound of the cummins engine.
johndeeredude97 3 years ago
i have smarty stacked with edge juice with attitude. however ts an smarty would be a good stack as well.
bonezilla23 3 years ago
smarty is by far the best for dodge/
kbf750x 3 years ago
no u cant stack anything with crazy larry.
only smarty with tst can be stacked.
kbf750x 3 years ago
I have a Bully Dog Crazy Larry edition programmer. Can you stack the Smarty with it? Also how much horse power does it add and how much does it cost?
Shanescumminsdiesel 3 years ago
is this the S-06 or smarty Jr? What do you think about the product?
tootootubular 4 years ago
wat is a smarty?
cumminsrocks 4 years ago
its a hi performance chip from mads electronics. it plugs in under the dash like a predator chip or hypertech if youre familar with those. if you have more questions just send me a message:-)
dieseldude74 4 years ago
Is that the 5.9L, or 6.7L Cummins?
kinglk5 4 years ago
a 5.9 the 6.7 didnt come out until 2007.5
DRhea357 4 years ago
who makes ur exhaust? sounds pretty nice
thess09 4 years ago
Silverline
RSWORDS 4 years ago
is there just a smarty done to this truck or other mods aswell?
yoshi470 4 years ago
Silverline
RSWORDS 4 years ago
sounds awsome that exhaust looks sick!
keep the vids coming!
im in the market for a cummins myself right now (not buying until i get my license in mid jan but im lookin around and there are a few used 02's isb for sale that i like)
s172mch 4 years ago