Proof Of Concept Ver2 6N3 005

[vipond50]

I'll attempt again tomorrow Your on the east coast correct?

What a good time for you?

Bill

[GULFCOASTCLEANENERGY]

TRIED TO CALL YOU BACK 985-276-3445

[GULFCOASTCLEANENERGY]

WHERE CAN I FIND 100% Rip stop Nylon (Uncoated type) ?

[vipond50]

@GULFCOASTCLEANENERGY 

[vipond50]

@GULFCOASTCLEANENERGY Seattle Fabrics dot com Look at the 1.9 oz material

[vipond50]

@GULFCOASTCLEANENERGY Where are U located?

I also asked if u had the planset... Do U ?

[GULFCOASTCLEANENERGY]

@GULFCOASTCLEANENERGY NEW ORLEANS I HAVE THE SET OF PLANS " 5 X 5 GAS SPLITTER " PDF FILE

[GULFCOASTCLEANENERGY]

WHERE CAN WE FIND THE MATERIALS TO BUILD CELL ?

[GULFCOASTCLEANENERGY]

HOW MANY LITERS PER MINUTE  ?

[vipond50]

@GULFCOASTCLEANENERGY

The 5X5 Ver2 was at 2.5 L/m if I recall when the video was taken. The 8X8 produces 6 L/m at it design spec. Please keep in mind the the gas are separated (2:1 ratio). Volumes were taken from both sides of the cell to look at Ratios and possible losses due to the electrolysis process and design.

Bill

[vipond50]

@GULFCOASTCLEANENERGY

The same places that you would source the materials for the standard Tero common duct searies cell. The only addition is the separater material membrane which is 100% Rip stop Nylon (Uncoated type).That the point of this design, it changes to a Biducted cell flow sheet.

Do you have the plans set????

Bill

[EletrikRidesAgain]

Thanks for sharing!

[insAneTunA]

Great job. Your flame looks much less orange, more bright white with a little orange on the outside edges from the flame. The orange might be caused by the air humidity and/or the metal from the burner. And indeed, oxygen does not burn without fuel. But even a small heat source might ignite any burnable fuel if lot's of oxygen is available. I'm glad you open sourced your design, I will check it out.

Best regards, iT

[vipond50]

Hello

The plans are in work and will be available thru Pancea University soon.

Contact Ash.

B.

[delvis11]

any chance you will be sharing your design for us to replicate?

vary nice cell.

[mikepowers420]

Sir, don't worry to much about the orto/para- hydrogen problume. I figured out how to convert para to ortho with very very little electricity.

Just as soon as I can get a copyright on the process, I'll post it on our water car site, and send it to you.

Peace.

Mike.

[vipond50]

Thanks Ash

John & I are working a set of drawings for your review. You will be constructing a VANT soon LOL

Take Care Bill

[ashtweth]

Some of your best work Yet mate. i am still drooling over the vertical Axis turbine