v8 (vawt,savonius,vertical axis,windturbine,hawt, ametek)

[DominickBlack]

I don't think you'll be getting a lot of torch out of that design.

I could be wrong though.

[emagnets]

@DominickBlack you r correct, tork is low on this design but the rpm is high, and that will counter balance the output.

regards

sam

[bullcurr]

oh man that looks cool!

[emagnets]

you should watch the other ones, and the latest ones i have created is the FAWT Silo...chech them out...thanks

[meterjuarez]

I found your design, so I can even install multiple generators in a minimal space.

What type of generators which use or recommend for this project here in Monterrey.

Thank you.

[emagnets]

my best design is the v8-4" and the best pmg for this vawt is the presto alterantor go to prestowinddotcom

please post your results, also please if you post it anywhere is to post the name "turbo spin v8-4" wrapwinddotcom

regards

[meterjuarez]

Very interesting desing, desing'm here in monterrey a type and installed on a vertical PMG 1 HP gives me 180 volts and 1750 RPM is what I need to install the dashboard and put the battery bank with inverter current to power a network of lighting in a house.

One question, I can say that PMG for this type of investor, how many batteries, and regulatory iliminar 10 to 100 Watts pockets.

Thanks and I hope your comment.

[sjh7132]

Nice looking! Do you have an alternator or is this just a decoration? How much power have you seen?

[emagnets]

sjh, this v8-3" was my first attempt for the sigar shape. i did not get much out of this one, the most i can remember was 6watts at 20kmh, i think. i was using and amtek 38vdc.

the winner is the v8-4", have you though about testing with it?? using your alternator? it looks hard to build, but it is no diffrent than waht you have built already. go to my site and see the DIY.

[msawusch]

Nice designs...which design spins fastest? what RPM can you achieve?

[emagnets]

thanks..it took many before it...

[emagnets]

v8 is faster at 150rpm in 5mph wind.

[emagnets]

i am still working on my Vanes design. all the info are on yourgreendream com or instructables com

[bg0821]

Nice neat job you did on this.