my cell was sealed so i am going to biuld one just like yours or try to. are the bolts 1/4 as your pdf says or are they 5/16" or 3/8". i am a machinist I like cars and if hho will green house great. but my set backs will not hold me back thanks
uh..smacks an 87 cutlass...in 96 something else happened to sensors, they started getting four wires..not sure but if you put a diode between the output of the sensor. heres how: 4 wires are output (in most common, like 98% of cars) a reference voltage that is from the ecm, and 12 volts and ground for a heater. the diode goes from output to ecm. thats right, silver band on diode going to cpu, chnges output from say .8 to .2 volts...lean burn mode..on most cars
my cell was sealed so i am going to biuld one just like yours or try to. are the bolts 1/4 as your pdf says or are they 5/16" or 3/8". i am a machinist I like cars and if hho will green house great. but my set backs will not hold me back thanks
rainmaker0909 3 years ago
You must have done something wrong with that sealed cell. they are more efficient by design. My cell is only about 6MMW at its best.
EletrikRide 3 years ago
i tried but but can not come up with mmw as good as yours. so to be honest i am building a reproduction of yours. that for your help
rainmaker0909 3 years ago
If you build a sealed cell you can get better MMW's than my open design.
ER
EletrikRide 3 years ago
how do you keep your cap from leaking? mine keeps leaking ive wraped the teflone tape round six times and used the pipe dope and still keeps leaking
wannab23123 3 years ago
Lots or thread tape, a touch of high temp grease on the threads helps, and tighten it down real good.
E
EletrikRide 3 years ago
what is your plate configurations?
rbeenlio 3 years ago
see my other vids and my site for exact specs
EletrikRide 3 years ago
uh..smacks an 87 cutlass...in 96 something else happened to sensors, they started getting four wires..not sure but if you put a diode between the output of the sensor. heres how: 4 wires are output (in most common, like 98% of cars) a reference voltage that is from the ecm, and 12 volts and ground for a heater. the diode goes from output to ecm. thats right, silver band on diode going to cpu, chnges output from say .8 to .2 volts...lean burn mode..on most cars
john29302 3 years ago
yeah, wide band O2's. Obviously not an issue with my car.
EletrikRide 3 years ago
Do you think mpg will be significantly better on smaller engines versus V8's and such, using these same techniques?
fergus247 3 years ago
Yes, the smaller the better
EletrikRide 3 years ago
wow pretty cool lessons learned - I will take them to heart.
Good job on the booster rally.
AlmostHydrogen 3 years ago
Is it OK to use just the O2 extenders, if I do not want to use an EFIE, since it pulls the O2 sensor out of the path of oxygen?
tolipapa1 3 years ago
I dont condone their use
EletrikRide 3 years ago
I mention in one of the vid captions that I am not using an EFIE
EletrikRide 3 years ago
Is any of your vehicule was using EFIE device to hack the oxygen sensor?
I am still listening all the others videos but did not ear about that so far!
labidus74 3 years ago