Lathe work 1

[Mrpsychotehpyro]

Nice surface whoah......

[sh345100]

حاجه جميله تستحق الاعجاب

ارجو تسجيل العمليات الاولى مثل الكروته واستعدال القوره والسنتر

[nonameHEF]

nice finish

[immcj]

Looks like cold rolled steel in my opinion

[cumulo25]

Is this stainless?

[Fourwheelsdk]

No just "ordinary" steel, if such a thing exists.. ;) Found it on the junkyard, so I hav no idea of what it was made up off.

[Axbent]

Think three times, measure twice, and cut once!

[JGMCNC1]

Ok, where's the coolant? Why arent you using coolant?

[Fourwheelsdk]

The pump was broken, so I give it a bit of oil now and then, thats why it smokes. Not the most optimal way to do it, but it works fairly ok.

[berry506]

sucks about that 0.02 mm but thats why they always say for precise measurments use a mic not a caliper. when tolerances are that close you got to you precise measuriung euipment. better luck in the future.

[Fourwheelsdk]

Bad..

I ended up taking 0.02mm too much of one of the bearing fittings.

But I learned to always use my micrometer screws instead of a digital caliper, even though the caliper has a resolution of 0.01mm

[Deusrexmachina]

And how did it go? :)