Turnigy vbar 600 v3 rocks!

[Sirricardo6]

Hi Ken,

Can you tell us what settings you are using on it. Cyclic gain etc...

[jbx907]

is this familiar to the horizontal stabilization or horizontal mode of HC FM CPII?

i mean it will fly like flying on rails, will prevent tip overs?

[PHeMoX]

@jbx907 No, it will just keep the heading in all axes. It doesn't auto-level to an upright (or inverted) position.

If you steer it in a certain angle it will stay there when you stop steering, but it's not doing any auto-leveling.

[osicran007]

what's the model and make of this heli? just curious.

[JacksonJSX94]

y it look unstable in the beginning of the hovering?

n ur tail look 'so soft' in locking..except when the tic toc n piro..

im planning of getting this fbl..need some more evidnce,proof bfore get one :)

[Reaper8520]

How does it work with the Gyro, do you still use your old gyro?

i have setup the align 3g on the T500 for one of my friends and it came with an gyro that replaced his tail gyro.

i want to convert my trex 450 sport and i like turnigy products.

Thanks

[Gourvelos]

Like the flying, like the stabilizer, followed the link from hobbyking but the music is a little too much lol, well done by the way.

[goraplx22]

delete that music.. because its shit.

[captainTubes]

@goraplx22 +1 I just wanted to hear the helicopter, then I was like >_<

[3benny3]

How does it do for holding the heli in place/stabilization for AP or FBL setup? Also is the built in tail gyro as good as it appears?

[johnnyphantom]

@3benny3 yes, the tail is as good as it is. Furthermore the settings very stock at the moment, fine tuning should get it even better. This is not a stablisation unit like the Helicommand, it is a flybarless system so it will not hold in a position for AP application.

[3benny3]

I was thinking you don't have to use digital swash servos, is this correct? Thinking about getting one for my T500

Very nice flying by the way

[Kenw4]

@3benny3 yes you can use analog servos for the cyclic

[schletzer1]

Hi

Great flight and the turnigy vbar 600 v3 rocks!

Which digital servos do you have on the swashplate and on the tail?

[Kenw4]

@schletzer1 Cyclic uses Hitec 5065 and tail uses Futaba 9257.