How to Countersink a Wood Screw

[silencesummer]

Excellent video, nicely narrated and demonstrated, thanks again!

[PUSSY100ish]

EXCELLENT DEMONSTRATION

[narceron]

Awesome...thank you.

[Eight3hirty]

Thanks ^_^

[Pterocarpous]

Thank you! Very well explained and demonstrated. Will look for more of your videos.

[OlRoguelO]

Informative video, thanks.

[kcimos]

@IAMAVERYGOODENGINEER he is going to fill the hole. he did it on purpose, were you not paying attention?

[Zaniaa2010]

@IAMAVERYGOODENGINEER sounds like a plan, wuut?

[Zaniaa2010]

@IAMAVERYGOODENGINEER what!? santa isnt real, all those years i though he was real.

[Zaniaa2010]

this video was aweful, through my experience of engineering, you must be the worst engineer i have seen. GET A LIFE! and just quit you job! YOU SUCK!!!

[joe588]

Thanks! I'm having a problem though, I'm trying to join two bits of plywood and every time I put the screw in, the other bit of wood moves away so it's not a tight join. I've drilled a pilot hole, still happens. Any ideas?

[kwikshowmehow2]

@joe588 Drill the hole in the first piece of plywood large enough that the screww can turn freely in it - without grabbing the wood. You only want the threads to grab the second piece of wood. It is the threads catching in the first piece that is causing the pieces to separate. Hope this helps...

[Pterocarpous]

brilliant! thank you for sharing this great tip!

[Zaniaa2010]

@joe588 listen carefully because im not going to repeat this..... you need to get some crazy glue then insert it into your nose, then it shoud work ;)

[stewartx5]

Nothing wrong with using a countersink drill bit, but I use a handheld countersink instead to accomplish the same thing. The sharp multiple cutting flukes require only a few turns to achieve a good countersink and I don't need to replace the drill bit with a countersink bit in the process.

[DailyBrusher]

Thanks, this is EXACTLY what I was looking for, just what I needed to know!!

[djibrl89]

thnx for sharing this