Intel Sandy Bridge i7 2600k LGA1155 unboxing & Installation

[YuuloEdits]

Today i installed this exact same processor on my p8z68-v pro/gen3 mobo that looks pretty much exactly the same as yours but it turns on for a couple of seconds then turns off, then turns back on and a red light named CPU_LED just stays on and it just does nothing... i can only guess it means the CPU is faulty =/ any ideas?

[SUPERMONJ]

@YuuloEdits Do you have another PSU lying around that you can swap and check. if it is still a problem , most likey the CPU or mobo

[YuuloEdits]

@SUPERMONJ turns out my CPU needs a dedicated power suply! i'm not used to these modern CPUs lol but i fixed it in the end thank god! was worried because i7s are not cheap haha

[joshthegreat666]

I don't think much to your method of applying the thermal paste, putting it on and taking it off leaves uneven high and low points sticking out from the surfaces, the high points obviously flatten first, if an area of high points flatten around an area of low points you can be left with a bubble of air, or potentially many micro bubbles, air doesn't conduct heat well. A pyramid would be the best shape, as the high point is always touching the cpu going out as it is pushed down, pushing air out.

[SUPERMONJ]

@joshthegreat666 Fair enough

[sayinmaster111]

Name of cooler Plz

[sweetxkhaos]

You also touched the electrical contacts on the processor but i'm sure it still works fine

[zilkoify]

@sweetxkhaos

Now, that is some really nerd geek pussy stuff right there.

[M4iich2011]

gives the place for everything with this fan without problems?It was very good xD

[crazychainsaw007]

I heard if u have higher ram speeds its harder too overclock so should I get 8gb of 2000mhz or 8gb of 1600mhz

[xpertbrewer]

Why does it say that the core i5 has higher frames per second then the core i7 on the Crysis stats towards the end of the video?

[ValeraDyachenko]

o my god!!!!you lozer!!!!!!

[saocir]

Does the fan comes with thermal compound already on?

[simpsda]

@saocir The stock fan does :)

[tonio819]

Apprends à écrire avant de poster des commentaire à la con ! tu n'y connais quedal en plus !! lol

[HiGhTiMeS419]

3:59 and those are the notches there.... pow...

Might wanna check if those pins that contact the cpu are bent after that one.

Something like that instantly voids any instore warranty you have.

[ForeverLaughing221]

Was it difficult to secure the cpu? I tryed to instal this on my p8p67 pro motherboard and it feels like it doesent fit

[iLessThan3MMA]

@ForeverLaughing221 I am having the same issue right now. I feel as though there is too much tension on the CPU and its going to snap.

[ForeverLaughing221]

@iLessThan3MMA It's fine, just press it down, it only just feels like theres too much tension. Im on the new comp now, It working great

[racheton0402]

thank you so much, very useful video.

[TasosEG]

:O wtf??

[michalaras3]

Perfect!!!!

[MultiHolywarrior]

you are cool man

[SUPERMONJ]

@MultiHolywarrior cheers :)

[pashka50000]

@SUPERMONJ  Cheers :)

[MrDhoobs1]

ur motherboard is sooooo nice

[WerewolfSlayer91]

you mounted the fan wrong. the fan who puts air out of the cabinett should be faced towards the heat sink and the other one should face (with the nactua mark )should face outwards. one pushing air in the other sucking..

[SUPERMONJ]

@WerewolfSlayer91 The first fan ‘pushes’ air through the radiator’s cooling fins, while the other ‘pulls’ air through from the other side, to the exhaust. in the video the nactua mark does face outwards to the exhaust fan.

[WerewolfSlayer91]

@SUPERMONJ Exactly. I don't want to be rude, but just wanted to point it out in case you didnt notice.

I get your point- which is pretty clear in your video as well as in your comment. I dont know if you want the air to be pushed further into the cabinet.I would like i towards the I/O ports. 10:29 you see the noctua mark is outwards. That means it chopps the air from the side with the noctua mark on it on to the other side. Pushes airtowards the RAM chips. The other fan:inwards=pulls air out.

[WerewolfSlayer91]

@WerewolfSlayer91 Well thats what fit my cabinett though. Well i realize now i was damn picky. But just turn the heatsink 180 and it would be as how i mounted it in the new PC i built. Good video by the way very helpfull. some iwssues with the mounting set which you put a spot light on. thanks for helping me build my pc.0Damn smal comments boxes cannot write what i want without shortening everything. and cutting out suff i rather be saying.

[SUPERMONJ]

@WerewolfSlayer91 sharp eyes. yes it seems like that i he vid. i placed the fan logo facing away from the ram. see my other video. water coolinf vs air to check. o i built a server pc and SSD vid cooming soon.

[SUPERMONJ]

@WerewolfSlayer91 am confused now ;( my noctua fans have air flow marking showing the logo side pushes air out. 

[88matheos1]

dude it will be not so complicated if you would install just the standard heat sink :p

[SUPERMONJ]

@88matheos1 standard one are of njo use if you overclock or need to think with the pc slient

[jackzvid]

im getting that exact rig only the motherboard is the rev 3

[crossfirex888]

what precautions did you take against static electricity like did you ground yourself or the motherboard?

[SUPERMONJ]

@crossfirex888 continually touch the unpainted metal part of the computer case to discharge any static

[WerewolfSlayer91]

@crossfirex888The only thing that is vurnable to the static electricity is the CMOS transistors. Which is mostly shielded today in most IC(Integratated circuits), like the prosessor and the chipps in the mother board which there are alot of. The CMOS transistor "detects" the volatge it its normal operation parameters(low voltage). The static electricity (which is normaly 1000 volts or much higher) destroys the "detecting" ability of the transistor =redering it useless.But do ground yourself. :)

[crossfirex888]

@WerewolfSlayer91 well explained thx

[ailouros1982]

what cooler is that?

[SUPERMONJ]

@ailouros1982 Noctua - NH-U12P SE2 Cpu Cooler . i have reviewed the cooler so feel free to watch it. plz sub :)

[KostasTheGhost]

lol youtube subtitling sucks xD

[mertrance]

i dont understand intel its bullshit they are making same fan to all cpu's its i7 and its same to dual core 2 ghz e2180 :D

[FutureComputing]

@mertrance most i7 users dont use the stock fan anyway

[jackzvid]

@mertrance yes thats because the new line of sandy bridge cpu's run a lot cooler than its predocessors, the coller is ample unless your overclocking.

[pranaysarkar22]

What's that display thingy with 100% displaying over the slot of your DVD drive slot?

[SUPERMONJ]

@pranaysarkar22  it is a nzxt sentry fan controller

[Daefen]

Love how the moment when he closes the lever it's magically skipped

[thelegacyization]

@adminworn really ?damn do i really need to buy a new mainboard jus for it mine got a LGA 1156 just one number of a difference,u kno lists of processors usable on my socket?

[thelegacyization]

PLEASE ANSWER ANYONE! SO THE 2600K WOULD FIT LGA 1156 SOCKET?

[adminworn]

@thelegacyization 2600K only fit to LGA1155

[WeirdoMikey2T]

@thelegacyization no the 2600k will not fit in a 1156 socket. The processor only fits in 1155 sockets.

[SUPERMONJ]

@thelegacyization 

[SUPERMONJ]

@thelegacyization no , only socket 1155

[SUPERMONJ]

@thelegacyization no , only socket 1155

[somebodyelse2255]

@thelegacyization NO but the FAN from the 1155 will fit the 1156 socket and vice-versa.

[ThePresD]

@thelegacyization nope but is kinda annoying how Intel screws you with one pin

[ifabulist]

3 DDR3? with 2600K? Looool xD

[SUPERMONJ]

@ifabulist ????

[ifabulist]

@SUPERMONJ Sandy Bridge processors will only support dual channel memory mode, rather than a three-channel, unlike the 1366-compatible

[SUPERMONJ]

@ifabulist I heard the new Sandy Bridge EX (socket 2011, expected q3), was gonna be quad channel

[ifabulist]

@SUPERMONJ no, LGA was gonna be quad channel, and Ivy Bridge (ex Sandy) was gonna be dual channel. Dual-mode speed is the same as a three-channel, four-and how, in the tests. But in this case (3 DDR3) you will lose 10-15% performance, because the memory works in single channel mode.

[ifabulist]

LGA2011*

[SUPERMONJ]

@ifabulist Yes Great point, thank you. Intel is targeting a 30 percent graphics performance and 20 percent CPU performance boost compared to Sandy Bridge. no matter what we buy, buy the time we try to fully use a CPU a new one comes out

[Helge129]

@SUPERMONJ I have a question about dualchannel: Does that mean the CPU can only properly use 2 RAM modules, or does it mean that using more than two RAM Modules doesn't run as good?

[SUPERMONJ]

@Helge129

if you want dual channel you need to do the following arrangement, using just two sticks

slot 1 | 3 | OR slot | 2| 4

So three sticks of RAM would be one dual channel + an extra stick. However if you fill all four you will be running two sets. Hope that clears things up.

[Helge129]

@SUPERMONJ Yeah, it does, thanks a lot =D

[leezaal]

nice video, finally getting my sandy bridge cpu next week still cant decide which will run games smoother either the 2500k or the 2600k with my gtx 570

[SUPERMONJ]

@leezaal thans. go with the 2600k.the 2600k has better overclocking headroom/runs at higher clocks with lower voltages than the 2500k.

[shaper87]

@leezaal The 2600k also has "Hyper Treading" giving you 8 ProcessingThreads in windows, instead of 4. So in theory the 2600k is Quad Core.

[SUPERMONJ]

@leezaal both is fine. games wont use 2600k fully