@stephk42 - Plenty of ways to do this depending on the application, in this case I used a bearing block. Soldered one side of the contact to the outside of the block, and reconnected on the other side with the hub of the bearing block. Its a bit of a grumbly contact, but fit for purpose, fill the bearing with mercury and it would be lovely. Look up 'slip rings'.
how'd you get the wires to be able to turn around and around like that without getting twisted up?
stephk42 5 months ago
@stephk42 - Plenty of ways to do this depending on the application, in this case I used a bearing block. Soldered one side of the contact to the outside of the block, and reconnected on the other side with the hub of the bearing block. Its a bit of a grumbly contact, but fit for purpose, fill the bearing with mercury and it would be lovely. Look up 'slip rings'.
scatalogic1 5 months ago
can't wait to see where this goes!
java0033 4 years ago