Parabolic Microphone for my Bionic Ear Amplifier Circuit

[s0ap001]

i saw the schematic diagram for the spy ears (evil genius), but where did you connect the parabolic mic exactly? we really need your help :(

[myvideoisonutube]

@s0ap001 You will need a DPDT switch. The switch will be used to disconnect each mic, and connect the mics on the parabolic dish. Disconnect the mics on one side then connect a wire from where the mic use to connect to the .1uF/1K resistor and run it to one side of the 2 MIDDLE pins on the switch. Repeat this process for the other remaining mic and connect it to the other side of the MIDDLE pin on the switch.Take one set of the upper or lower remaining pins on the switch and connect

[myvideoisonutube]

@s0ap001 the mics that you disconnected earlier, and connect each mic wire to one side of the upper or lower set of pins. Make sure they are both connect on the SAME set! On the remaining set of pins on the switch, connect the mics from the parabolic dish to each side. Make sure each mic is in the right spot for L or R. If wrong, switch the wires around on the parabolic mics. Take the other wires from the parabolic mics to ground.

[harpbloke]

i used a similar stainless steel bowl for my wireless modem, it worked great, improved my internet speed.