How to convert a points and condenser engine to electronic ignition: Part 1

[efman2k3]

what is the part number for the new coil?

[pivotboy63]

@efman2k3 briggs and stratton part #398593

[47485ksc]

@pivotboy63 Not to offend you, but you don't have to remove the flywheel to install an electronic ignition module. Just snip the wires off the old coil, remove old coil and bolt on new one. Takes about 10 minutes total. Why some people think this is informative, I don't know.

[pivotboy63]

@47485ksc i know you dont have to, but its better to do it this way so you dont have to worry about the wire getting caught on anything. if this wasnt informative to you, then why did you waste time watching and commenting?

[judgebean67]

Good info. Hard to see though.

[ringbolt9]

good info thanks i was looking for this !

[pivotboy63]

@ringbolt9 no problem, thats why i make these videos, to help others. be sure to subscribe

[facereader99]

u have an excellent subject, and content, but the presentation brings it down.

[pivotboy63]

@facereader99 ok maybe ill re-film it, im really busy lately so im not sure if ill have time. be sure to subscribe

[facereader99]

please delete this video, make another one, post it again.

[pivotboy63]

@facereader99 why?