Eowave Ribbon Controller

[salvadory]

will it control a doepfer dark energy module

[FlareHunter76]

Is it possible to connect this to a quarter-inch cable and then to an amp? Or to an eighth-inch perhaps?

[bigcitymusic]

@FlareHunter76 Sure, you could use a 3.5mm to 1/4" cable to connect it to your amp.

[FlareHunter76]

@bigcitymusic Interesting. Thanks for the reply.

[DaiReborn]

Whoa, a secy ribbon controller gets even sexier. I didn't know it lit up and didn't amazingness with light as well as sound! Also... No gate? WHAT? Can you get CV2 to stand in as gate? You must be using something to trigger the evolvers envelopes right?

[KeysBR]

Can it be used with the Minimoog Voyager?

How is it conected?

By CV Pitch and Gate outs?

[bigcitymusic]

@KeysBR There are 2 CV outputs (no gate). CV1 is controlled by the position on the ribbon and CV2 is controlled by the pressure on the ribbon or the tactile pad.

[BeverlyHills909303]

can it be used with the doepfer a-198 module instead of doepfer's own ribbon controller?

[bigcitymusic]

@BeverlyHills909303 I suspect the answer is, "Yes", but would not really know until we try it. If you are in Beverly Hills you are not far from our shop in Studio City. You are welcome to bring your Doepfer A-198 by and try it with the Eowave Ribbon.

[Nippe0000]

@bigcitymusic Thx