Milwaukee 12v impact driver review

[kryo101]

nice review, however it would have been nicer if you done a comparison with the drill driver and talked about what the differences are between the two, other than that, enjoyed your vids as usual.

[ultimatehandyman]

@kryo101

I started to do a comparison between the two, but I hit a knot in the plywood and it stopped one of them dead. I'll film a comparison when the weather is a little warmer. Thanks for the comment

[ultimatehandyman]

@Nibiru128

Thanks Chris ;-)

[BodyBuilder454]

Nice review vid. Will you be making any computer building vids in the future?

[ultimatehandyman]

@BodyBuilder454

Yes I hope to make some in the future.

Thanks for the comment ;-)

[FrankaDith]

Robertson screws and bit would've been much better lasting especially with the hammering action of the thing

[ultimatehandyman]

@FrankaDith

Thanks for the comment.

The actual pozi bit was a Milwaukee impact bit, but the bit holder was not an impact driver holder. I'll search for the Robertson screws and will check them out ;-)

[FrankaDith]

@ultimatehandyman Ha the Americans hate them just because they were invented in Canada but for this kind of a job they have no equal ,Phillips are use as drywall screws because the skip easy ,Robertson just do not give out.

[VAND4LL]

Another excellent review well done.

[ultimatehandyman]

@VAND4LL

Thanks for the comment

[tetsky1978]

how much are those set cost you normally??where did u get it from?thanks

[ultimatehandyman]

@tetsky1978

It was about £80 without the battery and charger which I already owned!

I bought them from ebay from the sellers listed below ;-)

[benny5825]

you can buy a special screw bit adaptor for impact drivers,i think its made by wera.

[ultimatehandyman]

@benny5825

Thanks, I'll take a look at that ;-)

[benny5825]

which ebay shop was it?

[ultimatehandyman]

@benny5825

I have been buying from tomp8294 and buyaparcel