Just trying to figure out what this was for I mean I understand it a prv but how do u know what pressure u have it set at I see u lapped it out so it was a good seal and had the thing threaded but how did u know where to put the tension nut that is what controls the pressure up and down to tight pressure gets to high and the whole thing blows to loose and it leakes?
@claysonacoleman The idea of this was essentially to vent an explosion. I didnt have a set pressure in mind. If you ever mess with an hho torch, you need something like this to vent a flashback.
Just trying to figure out what this was for I mean I understand it a prv but how do u know what pressure u have it set at I see u lapped it out so it was a good seal and had the thing threaded but how did u know where to put the tension nut that is what controls the pressure up and down to tight pressure gets to high and the whole thing blows to loose and it leakes?
claysonacoleman 1 year ago
@claysonacoleman The idea of this was essentially to vent an explosion. I didnt have a set pressure in mind. If you ever mess with an hho torch, you need something like this to vent a flashback.
pat1huey 1 year ago
Try using an air compressor for psi initial psi checks. Just n case
richcollins513 3 years ago
I'll do that on the new one I'm building. I'm sure this one isnt leaking at the valve, but I do have a weld that is leaking.
pat1huey 3 years ago