Blade 400 Tail Rotor DS285 servo set up w stock gyro 10 20 09

[Bags2723]

I've just been dealing with the same problem and after searching everywhere I finally broke down and paid a local hobby shop to fix it. They said they had to tighten the belt but the reason the tail slider drifted and " creeped " over Like you showed in your video is because the gyro settings needed to be adjusted in the DX6i gyro menu. I don't quite understand those numbers but once they adjusted them the heli flew again and the gyro held the tail solid. I'd like to understand more about that

[darkflamer]

Mate what are those landing gear and where did you get them? they are awesome. pm me if you can

[CrazyHeliDude]

Look like you got a winner vid here! Nice.

[Senegal01]

I think you found the problem. I reversed gyro on radio, and that seems to be big part of problem. Just little more adjustment and should be ready. This worked on both of my Blades.

[Tim1663]

Hi mate i had the same problem when using a stock gyro with the futaba s3154, anyway i found that if the gyro was set to NORMAL and not reverse and the Gyro was set to Reverse in the reverse menu on the setup list it seemed to cure the problem.

dont know if that any help to you but it worked for me.