Electricity Amplification by Neo Magnet (update)

[bnewton81]

3 cameras later...

[serialkiller1717]

cant you use a rotor with 4 contacts on it 90 degrees apart with a rheostat to control the speed to spike the amperage every time it contacts after all ac is made by a collapsing magnetic field that is what gives it its push and the faster you make a new field and collapse it should you get more amperage cause your spiking it and dropping it then spiking it a little higher each time till it catches up with how fast your rotor can spin

[verhaegenconstruct]

nice ;-)

[WinshieldWiper]

yo. theres something pretty fundamentally wrong with your setup here, your transformer wont work with just a straight dc current. A transformer utilizes the effects of a time varying magnetic field, provided by a time-varying dc current, or ac current through the primary to get a continuous production in the secondary. of course the bulb glows when the dc is pulsed, cause you now have time-varying dc. I cant say that the magnet has mutch to do with it tho,

[COsystem]

te recomiendo hacer pruebas con otros materiales inducidos toroidalmente ylograras electricidad gratis

I recommend you to make tests with other materials induced toroidal and you achieved electricity free

[boohoogetalife]

E=IR P=IE That's law Kirchoff's law tells us that you can only get out of a circuit what you put in, including losses by heat or light. You can step voltage either up or down with a transformer (or tesla coil). When voltage steps up, current decreases and vice versa. In both cases, power (wattage) is lost in the form of heat. You simply can't get something for nothing. The trick is to harness the sun's path through space. Waste of time.

[TheTruthPusher]

I read once in an article abotu the early days of radio 1921?  the article itself was from that time, and is suppressed, but it described using a transformer to double the amps in a radio.

[klexn]

1) Are you sure you know what you're measuring?? @ 2:15 "13-14 miliamps" @ 6:10 "23 miliwatts" Are you measuring watts or amps yo? As far as I know, not many meters measure watts unless maybe you have a 3rd probe to read voltage opposite of the current sample.

2) If you wanted to make your primitive freq generator last a little longer, Try a small .001uf ceramic cap and start working your way up in value till you stop getting arcing across the 2 terminals (heatsink and neo mag)..

[LINUXISNEXT]

How do i amplify speaker outputs to 1000 volt 0.3 Amps?

[LoneOarman]

Disposable Flash Camera Circuits all over the web.

[crackahcrackah]

This looks similar in function to Tesla's high frequency current circuits(the one that uses inductor's to convert environmental energy to electrical energy. you should look up those patents. Look up N. Zaev's work also. In the process of building a PWM that hit's pulsing rates of up to 44Khz. Should be fun... I can only imagine 150Khz and up. That particular area of Tesla's work is the most fruitful for mankind.

[dividebyN]

It disturbs me every time I see a reference to Tesla in these 'over-unity' videos. Tesla was the pioneer of A.C generation, commutation and distribution. He DIDN'T invent any devices capable of creating energy from thin air! (Contrary to what some might have you believe)! He explored the resonance of the planet and the distribution of electricity by using its OWN field and resonance. All the electricity HE used HE generated! He only used the term 'aether' in the abscence of a better description!

[crackahcrackah]

over unity is a terrible term and it is used loosely by people who have no clue what Tesla what doing. You don't seem to understand what Tesla was doing either. Pleas study his High Frequency patents and research. Energy was never created, merely transformed from one form to another. And yes it is possible to use a fraction of energy to convert a much larger amount to a usable form. Just like solar panels convert energy from one form to another, albeit inefficiently compared to HF Telsa patents

[dividebyN]

I'm not going to argue over FACTS. I'm also not going to ridicule you or put you down! I can only think you've managed to delude yourself somehow into believing you're onto something with this! btw, you arent even reading your instruments correctly! Your clamp meter is measuring current and you are quoting watts. Yawnnnnnn....Good luck and keep on experimenting!

[crackahcrackah]

Yeh, the FACT is, Tesla's high frequency current patents ALL give a device geometry such that the area under the curve for energy is substantially larger as time approaches zero from when the contact is made/broken than when time is further away from when the contact was made/broken. The N. Zaev paper of the inductive conversion of thermal energy to electricity shows this and some nice graphs energy over time with this high frequency current phenomenon.

[Eddlipton]

So let me see if I get this,, by pulseing you are creating cycles, like 60 hz and by pulsing the D.C. you are enegizing the torroid and colapesing at that cycle bumping UP VOLTAGE, correct?

[gotoluc]

Yes Eddlipton,

you are getting it. You can look at a coil like a heavy flywheel. If you give the wheel a push you store energy in it and you can get it back less friction. If you pulse push the wheel you can have it evenly doing work to something that is attached to it. However you cannot have something attached to it that require more energy (work) then what you put into the wheel.

Luc

[Eddlipton]

Okay, then,,so how about helping me find a wave tek like you have there for a resonable $ ha ha! No seriously I can't find one anywhere on e-bay or anywhere

[gotoluc]

Hi Ed,

I'm working on a circuit that would be a signal generator with Pulse width (duty cycle) adjustment and control of 2 independent switches which are 90 degrees out of phase (flip flop)

Just wait a few weeks and I'll let you know when it's ready.

Luc

[ez3usx2]

if you want to die just make a fuel saving device and refuse to sell it to the oil companies.the oil companies and their trillion dollar business run the goverments and universities.the oil companies should be charged with treason and we can start with standard oil company for selling the germans special fuel for their planes during ww2.the people of the world wont be free until we kill the oil companies.

[AccuracyMarked]

13ma DC or 24ma AC when magnet installed.....it's a magnetic switch.....no amplification here.

The light-lamp lumins intensity increase is not indicative of amplification...rather your feeding more current through the bulb AC wise.

[DarkTemp0]

actually it reminds me of those old dor bells with coils and a magnetic arm :)

this is just smaller scale :P

Anyway nice to see at there are people who know what is going on here

Simple electromagnetism (highschool physics)

[mump0op0o]

i played wif magnets wen i woz like 10

[farislucas]

Not helping your case...

[Zeropointmicron]

Hi Luc,

additionally I'm thinking that the voltage which goes through the magnet is modulating the magnetic field from the magnet itself. It must be in the range of 5 Khz ore more, otherwise the coil would not ignite the spark. There is a paper(pdf) on panacea-bocaf Online University about a MRA (Magnetic resonant Amplifier) which describes how to gain energy from a magnet(but in a different way)- it takes a piezzo to oscillate the voltage.

Nice Greetings

Micron

[gotoluc]

Hi Micron,

your ideas sound good and I hope you can try them since I am working on another project at this time.

Thanks for taking the time to share your ideas and I do hope you can test them and find the way to use this effect.

Luc

[Zeropointmicron]

Hi Luc,

the second ideas is to try to pick up current/voltage with a blank wire from the mag, like a second loop and grounding it on an extra capacitor. But the resistants in the new created loop must be lower than in the loop of the ignition coil, otherwise

the current/voltage will not going also through the second paths. Maybe it will works with caps they're have normally a low resistants. Let me Know what do you thinking about.

Thanks Micron

[Zeropointmicron]

Imagine you could use a big cap instead of the lamp

[gotoluc]

Hi Zeropointmicron,

thanks for looking at this interesting effect. You are right! you can charge a cap with it but either way I have not found a way to get over unity using this method due to my lack of understanding the correct way to use this effect.

Luc

[Zeropointmicron]

Hi Luc,

i have just two ideas: what if you take a longer cylindrical neomagnet instead of you little one, and wrap a magnet-wire around the magnet. like a coil. We have Oscillations otherwise the ignition coil would not work. so there must be a oscillating magnetic field that cames from the magnet. Normally we must taken up an alternating current from the wrapped wire around the magnet. -futher on both end of the cylindrical mag you connect the wires from the ignition coil. Greets Micron

[Zeropointmicron]

The pulsing is the best evidence that a magnet has no static field.

[Zeropointmicron]

Hi gotoluc,

this is what Tesla did, adjusting or modifying spark-gap with magnets. I'm thinking that this is a kind of OU because the magnet is sucking/polarizing neutrino over the spark itself, this a type of method to use a magnet to have more electrons materialized from dirac sea in the wire. This could be used for producing serious amounts of electric power. Referr to Tom Bearden a magnet have no static magnetic field it has a field in a steady state flow from the quantum field. the pulsing

[johnb003]

So my main point is you can do the same thing with a relay which probably has better materials to handle the sparking, and mechanical motion is done without using the magnet as a conductor.

In either case you'll not really be able to use much current, so in the end you're probably still have to use a mosfet or transistor, and lastly you'll get more control with the 555 timer circuit. It's just charging and discharging a capacitor through resistors based on 1/3 and 2/3 voltage comparisons.

[johnb003]

The relay I did that to fried somehow, either the mechanical lever sparking created an insulating coat, or the coil burned up from voltage spikes but anyway, I suspect what you have created with the magnet and the wire achieves a similar effect.

As current flows through the wire you get just enough of a magnetic field to repel the wire off of the magnet, which then collapses and oscillates.

I love the oscillation but the sparking is undesirable, as well as the heat in the mag from conduction.

[johnb003]

Interesting stuff!

I don't think this is quite the same thing happening with my magnetic quench though.

Once when I was a kid and I had one of those 2001 electronic kits with a bunch of parts and springs to connect to the receptors I thought to myself, what if I connect the electromagnet part with the closed path of the relay. That way, when the current flows the magnetic field will build up strong enough to sever the contact, which would in turn collapse the field and cycle over and over.

[crackahcrackah]

You should look into Tesla's single wire transmission of electricity patents and how that mechanism is employed in the Stan Meyer's and Bob Boyce toroidal energy transformation/inductor units. <---Very good stuff!

[aaronplant]

what happens if u touch it

[gotoluc]

What part?

[webixxx]

nice radio waves :-)

[cavetronics]

When you combine the magnetic flux from the neo mag and the input power from your power supply

you have a gain as you will see the magnet has a coating around the flux and you change the amount of flux round the magnet and the BEMF supplys more to load the cap also the shorting out across the magnet couples with the power supply

[gotoluc]

Hi crob227,

I did not know that! maybe that is why it self oscillates when on the correct pole of the magnet.

I really like this effect. Did you see the video that I pulse a coil with the magnet and get the spark to jump over a 1/2" gap?

Luc

[crob227]

you got some great work, im gonna go back through all of them,,, thanks again for all your work.

[crob227]

Did you know that a spark makes a magnetic pulse??? i showed it on a video i made about the water spark pt 2 or 3.

so what if the plug setup everyone's playing with is acting just as your magnets doing.

i have seen and shown some wild stuff on the tube dealing with spark plugs.

great video wonder why i never seen it till now? 5stars

[prototype9000]

hmmm interesting ill give that a try on my transformer reminds me of the time i was experimenting with a telephone ringer

[ag72]

very cool, can you tell use what inside the toroid coil disc PLEASE IS IT ALSO A NEO MAGNET & WHAT GAUGE WIRE & HOW MANY TIMES IS THE DISC WRAPPED? Keep up the GREAT vid's.

[gotoluc]

Hi ag72,

nothing special on the toroid! you can use most any transformer. Some work better than others. Experiment and find what works best.

Luc

[ag72]

Tks very much for the reply, does the neo magnet & the toroid product volts without house/120 volts added...ALONE? just the neo & toroid coil.

[gotoluc]

No, I am using 12vdc though the magnet.

Luc

[dreckka]

Excellent!!!

Very well Done!!!

[mastergroundscrew]

Hmmm, very interesting. I will have a play around with that.