Yes it did but remember that my car is FI not sure if it would do any for a NA car. The header added 7 rwhp but the biggest different was that the engine spools (rev) a whole lot faster. The car now makes 330 rwhp look it up on another posted video.
Aprox 2800 lbs I havn't weight the car but after removing some OEM and added other lighter components I think is somewhat a bit lighter than OEM. I should weight the car in the near future.
@Sk8FalIen They weigh between 2900-3030 depending on the options, not too bad for a 4 door car. The 1993-1995 US RX-7's were smaller at 2700 lbs, but they were only two seaters.
-BC Racing Coilovers -Pettit Racing Stage II Super Charger with ECU Flash -Mazdaspeed Front Strut Bar -Mazdaspeed Rear Strut Bar -MazdaSpeed Shift Knob -Axial Flow Short Shifter -Exedy Stage 1 clutch -Personal Homemade Cooling Fan Modification -Snow Performance Methanol Injection Kit II -Toyo Proxes R1R 245-40-18 -G-Games 77W Wheels -BeatRush Center Transmission Bracing
I think I like the Racing Beat ground effects more than the Mazdaspeed body kit. Looks nasty. 8 psi run I'm guessing? And how many lbs-ft did you have to the wheels?
is that the veilside bodykit ? has this rx-8 the greddy turbo kit on it? i'm searching for a intercooler to replace my original for my rx-8 but i dont wanna buy the turbo kit and no universal .. it doesnt seem to excist for rx-8
with the S/C does it shortened the engine life like the turbocharged....
fuaad85 1 year ago
Did the Ingalls Stiffy Dampner make any noticable-good difference?
What about the header?
I have a cat-less Agency Power 3" full exhaust and it added 12.5 rwhp on the dyno, but I heard the headers really didn't add much, like 2 or 3 hp.
Chrisnuzzo76 1 year ago
Yes it did but remember that my car is FI not sure if it would do any for a NA car. The header added 7 rwhp but the biggest different was that the engine spools (rev) a whole lot faster. The car now makes 330 rwhp look it up on another posted video.
marsredr100 1 year ago
how much do these cars weight?
Sk8FalIen 1 year ago
Aprox 2800 lbs I havn't weight the car but after removing some OEM and added other lighter components I think is somewhat a bit lighter than OEM. I should weight the car in the near future.
marsredr100 1 year ago
@Sk8FalIen They weigh between 2900-3030 depending on the options, not too bad for a 4 door car. The 1993-1995 US RX-7's were smaller at 2700 lbs, but they were only two seaters.
Chrisnuzzo76 1 year ago
What stage is this particular Pettit application; I, II, or III?
Ralli2Yazh 2 years ago
It is the Stage II with the bigger pulley and fuel injectors. I guess it can be called Stage II version 2.0
marsredr100 2 years ago
what is 0-60 time now with the SC?
genocyde83 2 years ago
you gotta get it to 300 hA, anything you coul do do???
ashleyadams82 2 years ago
how much torque at the wheels?
brakehorsepower 2 years ago
what else is under the hood/car besides the supercharger??
forkedroad 2 years ago
-Racing Beat Catalytic Converter Replacement Pipe or
-ExoticSpeed Hi-Flow Cat & Resonator combo
-Racing Beat Exhaust System
-Racing Beat Stainless Steel Brake Line Kit
-Racing Beat Stainless Steel Clutch Line
-Racing Beat Aluminum Flywheel
marsredr100 2 years ago
-Racing Beat Oil Cooler Screens
-Racing Beat Front Sway Bar
-Racing Beat Rear Say Bar
-Racing Beat Front Sway Bar End Links
-Racing Beat Gauge Kit (Water Temp, Boost/Vac, Intake Air Temp)
-Racing Beat Type II Nose Kit
-Racing Beat Side Skirts
-Racing Beat Rear Spoiler (wing)
-White Line Rear Adjustable Sway Bar End Links
marsredr100 2 years ago
marsredr100 2 years ago
-BeatRush Arm Bracing
-BeatRush Rear Differential Support
-BeatRush Under Panel
-Mazda OEM 2009 model under panels
-Mazda OEM 2009 fuel injectors for P2 and Auxiliary position
-AEM Air Fuel Ratio gauge
-Cyberdine Engine Temperature, Intake Temperature, Boost Pressure, Water Temperature gauges
-BHR Aluminum Radiator
-Cquence F&R Crossed Drilled Brake Rotors
marsredr100 2 years ago
-Ceramic F&R Brake Pads
-Optima Red Top Battery
-MSD 8247 Ignition Coils Modification
-MSD Super Conductor 8.5mm wires
-EFI Dude Data Logger
-ExoticSpeed Header
-Greddy Oil Pan
-Buddy Club Racing Spec Condenser Grounding Kit
-Ingalls Performance Suspension Stiffy Engine Torque Damper
-Mazmart Water Pump and Modified Thermostat combo
marsredr100 2 years ago
Almost 300 ponies on a 1.3 liter, JESUS FRIGIN CHRIST that's ridiculous
boosted04specV 2 years ago
not really :P
flip3d 2 years ago
does the sc let you rev all 9k? or does it cut you off?? it doesn't sound like 9k to me
mehmehxxx 3 years ago
Pettit set the rev limit to @ 8500 since peak power on a sc renesis is achieved @ 8200 rpm. Therefore there is no need to go past 8500 rpm.
marsredr100 3 years ago
Exactly plus the P2 injectors were changed from the stock 380cc to 440cc to compentasate for the additional boost.
marsredr100 3 years ago
how high is your psi? 10psi for this run and 11psi for the 327whp?
yourmotherrules 3 years ago
damn that revs fast as fuck
YoItsDLeV 3 years ago
supercharged renenis is a sweet deal.
veltpak6 3 years ago 4
299 HP, from a 1.3!
Fwertz 3 years ago 11
Google pettitracing for website and information
marsredr100 3 years ago
Check the Pettit Dyno thread for dyno graph and more.
marsredr100 3 years ago
I think I like the Racing Beat ground effects more than the Mazdaspeed body kit. Looks nasty. 8 psi run I'm guessing? And how many lbs-ft did you have to the wheels?
wasp010 3 years ago
It is a Racing Beat body kit. It has a Pettit Racing Super Charger not a turbo kit.
marsredr100 3 years ago
is that the veilside bodykit ? has this rx-8 the greddy turbo kit on it? i'm searching for a intercooler to replace my original for my rx-8 but i dont wanna buy the turbo kit and no universal .. it doesnt seem to excist for rx-8
SLAYER666NR1 3 years ago