V-led jdm sidemarker: Bulb 194/168 Wedge SMT x5 HIGH POWER

[alexvaldana]

Oh man, that is the only part of my car on which I don't have v-leds. Just tell me something, did you have to install load resistors for the sidemarkers too? Thanks!

[NewShockerGuy]

@alexvaldana

This wasn't actually too bad! I went to superbrightleds and went to their 12volt bulb section. You will see towards the bottom of the page they have something called and electronic relay. What this is, is a direct replacement depending on your car replaces the stock relay. Since my car is japanese, I went with the 3 pin japanese electronic relay. It's about 12 bucks but the awesome thing about it is now you can have ALL leds, ALL bulbs, or a mix of both and they will

[NewShockerGuy]

@alexvaldana

Part 2 of what I was saying:

All flash at the same speed! This is completely plug and play and you don't have to worry about using those stupid resistors or splicing ANYTHING. Unplug the stock relay. Plug harness (my case 3-pin harness) directly into electronic relay and you are done. Turn the signals or flashers on and they all blink at normal rate and not hyperflashing. Very very simple thing to get and for 12 bucks you can't beat the NO hassle approach!

-N