Woodworking-22...Let's Build a Jewelry Box...Part 5 Wood turning

[Sodabowski]

I'd switch the CA glue for something that doesn't show when finished...

[AppJourneyman]

@Sodabowski

Normally, I would have chosen a white or yellow glue to apply the turned knob to the lid. However, what you do not see in this video is that it was over 105 degrees in my Las Vegas NV shop at the time. I chose CA glue for an instant glue-up so that I could complete the project. In this case, the CA glue does not show or affect the finish at all.

[mersyturning]

well turned. knobs are hard to make especially if your making more than one to match

[AppJourneyman]

@mersyturning

You're right! The same holds true for turning salt and pepper mills.

[mersyturning]

@AppJourneyman you would think they were easy too, ive jus turned four legs and its a good job the legs are 18" apart because there are a few obvious diameter differences lol

[AppJourneyman]

@mersyturning

Aside from me I bet there is only one other person that knows about it tho.