Skiffybusiness1
Loading...
Hoopnet pull 2
Another Hoopnet Pull while lobster hooping from my kayak.....nothing in the net...then again if it wasn't slow I wouldn't of been playing with me c...
Skiffybusiness1
uploaded
hoop pull.AVI
Just another hoop pull off my kayak..Paddling up picking up the float takes about a minute the actual pull only lasts 15 seconds.
Skiffybusiness1
uploaded
Spyderco Byrd PFD folding knife demo
A semi- tongue and cheek response to the great "safty knife" debate at BWE.. Here I am playing around with my Spyderco Byrd Crossbill (Hawkbill) fo...
Skiffybusiness1
uploaded
Cutting Aluminum with a Makita, 7-1/4, Circular Saw (Kayak building)
Cutting out the 5038 Aluminum16 gauge hull segments for my aluminum 21 ft open ocean fishing Kayak. This is the first step in building my kayak if ...
Skiffybusiness1
commented:
mako
Mako Jumping: We hooked this one on a mack right outside of Avalon, didn't last long.
Skiffybusiness1
uploaded
Magging a Avet SX casting test 1
This is a video of me testing my modifications to a older Avet SX lever drag reel. These older Avets have no cast controls so they are pretty bad...
Skiffybusiness1
uploaded
The World's First Surfing Mice - The Radical Rodents
You will not believe your eyes !!!
Hello we are the Radical Rodents, the coolest and hippest mice in the world. We are all mad keen surfers and as ...
Skiffybusiness1
commented:
Bottom line if they did not enjoy it they would of never let the guys put them on the board a second time. Some of these rats are in three or four shots, which means they have no problem with it.
Cutting Aluminum with a Makita, 7-1/4, Circular Saw (Kayak building)
Cutting out the 5038 Aluminum16 gauge hull segments for my aluminum 21 ft open ocean fishing Kayak. This is the first step in building my kayak if ...
Skiffybusiness1
uploaded
La Jolla Kayak Launch
Kayak Launch at La Jolla California with a little live Nirvana and some Hemingway quotes. Nothing spectacular but it all fits together.
Skiffybusiness1
uploaded
Yep you got that right., that blade will grab and get thrown right into your lap if your not careful. You have to hold the saw absolutely perfectly steady during the whole cut and that would be very hard to do with a grinder.